Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: The Barge Captain on 07 December 2007, 12:33:25

Title: Estate tailgate glass removal
Post by: The Barge Captain on 07 December 2007, 12:33:25

Is it viable  / easy to remove and refit the glass in the tailgate of an estate?

Title: Re: Estate tailgate glass removal
Post by: stevief on 07 December 2007, 12:51:21

According tothe guy that resprayed the tailgate the glass is bonded in so specialist required.

Steve

Title: Re: Estate tailgate glass removal
Post by: The Barge Captain on 07 December 2007, 12:53:16

OK.  I do know a nice chap who works for autoglass.  I'm sure he might be bribed with some Stella.

Title: Re: Estate tailgate glass removal
Post by: Golfbuddy on 07 December 2007, 12:58:02

Tailgate Screen, Remove and Install - Models F35, M35, P35

Remove

Note:   When carrying out the operation, observe in particular the general information - see "General notes on cemented windows".

Rear wiper arm, tailgate inner panelling - see operation "Inner Panelling - Tailgate, Remove and Install", tailgate screen wiper motor - see operation "Wiper Motor - Tailgate Screen, Remove and Install" in Group "N". Disconnect wiring harness plug for "heated rear screen" (1).

Detach screen trim strip around entire perimeter, detach mounting strips.
  
Note:   Mounting strips cannot be removed undamaged and must be replaced.

Cover windscreen frame with masking tape to prevent paint damage.

Remove

Note:   Cover windscreen frame with masking tape to prevent paint damage.

Remove tailgate screen with Wire Cutter MKM-589-B:

In the tailgate screen wiper motor area (1), push wire cutter through adhesive bead from the inside outwards with pliers. Remove tailgate screen around entire perimeter, wire cutter length approx. 400 mm.

Cut out glass from tailgate screen with Cutter MKM-846-1E or MKM-846-1P:

Insert Cutting Knife MKM-846-28 from outside in area of tailgate screen wiper motor (1) and cut out glass from tailgate screen in a circular motion.

Remove tailgate screen using Screen Suction Lifter MKM-641 and lay aside on holding device.
  


Install

Smooth down adhesive bead on tailgate to a thickness of 1 mm using Scraper MKM-846-70.

For re-used tailgate screens: Reduce adhesive bead to a thickness of 1 mm with Scraper MKM-846-70, attach new mounting strips (1) and screen trim strip.

For new tailgate screens: Clean adhesive area, attach new mounting strips (1), screen trim strip, apply "black" glass primer and allow to dry for 15 minutes.

Apply glass adhesive, use pre-cut applicator nozzle. Install tailgate screen with Screen Suction Lifter MKM-641, only tension tailgate screen slightly with Tensioning Belt MKM-591.
  


Caution

Lay-over times for freshly cemented glass panes in connection with glass adhesives and airbag equipment – see "Vehicle Lay-Over Times". Observe adhesive manufacturer's processing instructions and those on packaging.

Install

Wiring harness plug for heated rear screen, tailgate screen wiper motor, tailgate inner panelling, rear wiper arm.


Looks like a bit of a nightmare to me. Might be better to get an autoglass company to remove and refit for you??  They should be able to do it without breaking the glass as it's toughened not laminated like the windscreen.  :y