Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: rubbetteboy on 27 March 2008, 16:42:01

Title: 2.0L crank sensor fitting
Post by: rubbetteboy on 27 March 2008, 16:42:01

Hi...can anyone tell me whether there is supposed to be a rubber seal or similar fitted to the crank sensor. Since fitting a new one the engine refuses to start. With the old one it run sluggish and was difficult to start when left for a few days. Is there any particular way of putting them in, it seems so straight foward, but maybe I am missing something.  Cheers. :y

Title: Re: 2.0L crank sensor fitting
Post by: Dazzler on 27 March 2008, 17:01:34

Did you change just the sensor or the cable as well??

Title: Re: 2.0L crank sensor fitting
Post by: rubbetteboy on 27 March 2008, 23:38:53

I replaced the wiring aswell

Title: Re: 2.0L crank sensor fitting
Post by: Dazzler on 28 March 2008, 09:26:41

Was it a genuine sensor or aftermarket?

Title: Re: 2.0L crank sensor fitting
Post by: rubbetteboy on 28 March 2008, 23:35:22

Thought you might ask that...it was an aftermarket job. I only replaced thew wiring up until the connector and not all the way back to the ecu to be honest.