Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: andycab on 27 October 2008, 00:26:08
-
.
My garage recently drained some coolant to replace crank pulley,even though coolant is topped up to correct level and running ok my "CHECK COOLANT warning is on,do i have to reset it somewhere,also is there bleed screw for refillig coolant.
thanks
-
.
My garage recently drained some coolant to replace crank pulley,even though coolant is topped up to correct level and running ok my "CHECK COOLANT warning is on,do i have to reset it somewhere,also is there bleed screw for refillig coolant.
thanks
andy
it's not unusual for sensors to get gunked up in the coolant header tank, normally means new bottle. about 30 notes from VX. as for bleed screw the only bleed screw i know of is on the bottom right of radiator, but what about using the header tank for refilling.
hth
-
why did they drain coolant for that :-/
if coolant at correct level, check that they haven't disturbed plug under coolant bottle
-
OK THANKS FOR REPLIES,THEY HAD TO DISSCONECT OIL COOLER FORACCESS APPARENTLY
ANDY
-
OK THANKS FOR REPLIES,THEY HAD TO DISSCONECT OIL COOLER FOR ACCESS APPARENTLY
ANDY
Why did they have to dissconnect the oil cooler to do the crank pulley, when its at the front, bottom centre of the engine? They don't need to touch the top of the engine at all!! Unless I am missing something here :-/
Paul :y
-
wait? did they undo something at the top of the engine to get access to something at the bottom........ :o :o :o :o