Omega Owners Forum
		Omega Help Area => Omega General Help => Topic started by: Martin_1962 on 30 December 2008, 19:55:08
		
			
			- 
				I need one, how easy and how much are parts.
 
 Also might need front bushes on wishbones, again does the MDTM jig work?
- 
				If you do the wishbone bushes, you may have to pay for WIM again  :-[
			
- 
				If you do the wishbone bushes, you may have to pay for WIM again  :-[ sounds like they couldnt do it, due to the above, probably didnt charge?
- 
				If you do the wishbone bushes, you may have to pay for WIM again  :-[ 
 
 They were borderline and I think I have a free check in 1000 miles don't I?
 
 He said camber would be fine
- 
				I need one, how easy and how much are parts........ 
 IIRC about £30  :-/ MarksDTM posted a link to eBay, which is where I got mine from. Hardest bit to changing the idler is persuading the taper to let go cos you don't have much room to swing/hold a pair of hammers. ;) Not difficult though.  :y  :y
 
- 
				These are teh weapon of choice....
 
 http://cgi.ebay.co.uk/Vauxhall-Omega-Carlton-Steering-Idler-Arm-110mm_W0QQitemZ230305502808QQcmdZViewItemQQptZUK_CarsParts_Vehicles_CarParts_SM?hash=item230305502808&_trksid=p3286.c0.m14&_trkparms=72%3A1301%7C66%3A2%7C65%3A12%7C39%3A1%7C240%3A1318
 
 
 Beware of pattern items, they dont fit welladn dont last long.
 
 I would of thought just changing wishbone bushes would have minimal effect on the settings....asuming they were set up in a non-loaded state (which I am sure they were).
- 
				Ordered - I will chance the wishbones and the exhaust manifold gasket.
 
 If JV6CDX is watching - how much to do a drivers side gasket?
 
 My hands are a bit big for these down the side of engine stuff
- 
				If you change the wishbones themselves (as opposed to the bushes), it probably will mess up the alignment. 
 
 Must have taken a couple of mm of tread off my fronts just driving to the tyre depot afterwards. It had about a degree and a half of toe-in.
 
 Kevin