Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: AndyVXR300 on 25 April 2009, 20:27:42
-
I'm planning if its possible to tranfer the following from a pre facelift S REG MV6 into a Facelift V6 CDX W REG
The key question is it possible ???
3.0 engine and box
MV6 front/rear seats only
full front/rear suspension
Thanks
Andy :y
-
Should all be fine mate...
If your getting the ECU with it, make sure you get the security code...just in case you need it later :y
-
why not just fit the 3.0 cams to your 2.5 for an extra 18bhp and a lot less hassle.
(obviously it's not legal ::) but i certainly wouldn't bother telling my insurance company about different cams ;))
-
why not just fit the 3.0 cams to your 2.5 for an extra 18bhp and a lot less hassle.
(obviously it's not legal ::) but i certainly wouldn't bother telling my insurance company about different cams ;))
I have also thought about this option but have had conflicting advice based around
The uprated cams produce around 10bhp on their own in a 2.5
To run these properly on a 2.5 you will also need a freeflow exhaust, performance air filter a re mapped ecu etc etc
I'm a novice to the V6 and take on board any advice given... the above information was forwarded from someone off another forum i would like to add and not this one :y
Andy