Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: SJKOO01 on 22 May 2009, 20:56:22

Title: A-pilliar covers - How to remove them ?
Post by: SJKOO01 on 22 May 2009, 20:56:22
Hi.

Need to remove the Passenger & Driver A-pillar covers on a facelift model, to run some electrical cable down them for an accessory.

Just need to know if its a simple case of unbolting the grab handles, and unclip the covers, or do you need some kind of special tool to take them off, as don't want to use a large blade screwdriver in the assumsion that the just unclip, then I go and break them ?!.   >:(

Can anyone advise please ?

Thanks.

M
Title: Re: A-pilliar covers - How to remove them ?
Post by: kcl on 22 May 2009, 21:03:17
IIRC There are two or three "regular" type of clips that are attached to the pastic cover and the pin-end of the clip goes in a hole in metal (could it be explained more unclear  :D ) But you'll figure it out when taking the cover off, just needs to be pulled sharply to free the clips.
Title: Re: A-pilliar covers - How to remove them ?
Post by: SJKOO01 on 22 May 2009, 21:11:19
Thanks for letting me know  :y
Title: Re: A-pilliar covers - How to remove them ?
Post by: MikeDundee on 23 May 2009, 06:06:21
heres some pics of the b/c pillars :y

(http://i85.photobucket.com/albums/k65/mickdundee_01/2008_0109CPILLAR0014.jpg)

(http://i85.photobucket.com/albums/k65/mickdundee_01/2008_0109CPILLAR0012.jpg)

(http://i85.photobucket.com/albums/k65/mickdundee_01/2008_0109CPILLAR0013.jpg)

(http://i85.photobucket.com/albums/k65/mickdundee_01/2008_0109CPILLAR0015.jpg)
Title: Re: A-pilliar covers - How to remove them ?
Post by: SJKOO01 on 23 May 2009, 19:45:34
Thanks for sending pics for other pilliars.

Managed to do the job without too much trouble.

Regards

M