Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: barclay03 on 25 September 2009, 21:15:33

Title: V6 not starting **update with EML light**
Post by: barclay03 on 25 September 2009, 21:15:33

Having a little problem with my MV6. I've just changed the cambelt and also cam cover gaskets (all done as per the OOF dvd and guide)... but on completion the car wont start  :-?

Its turning over the fine, timing was ok, but it just keeps turning and turning (with a few hiccups) like its not getting the fuel - have i missed something in regards to pressurising the fuel rail again or anything? its also new spark plugs that are in it too

Probably going to pull it all apart again tomorrow and double check timing etc  ::)

Title: Re: V6 not starting
Post by: Jimbob on 25 September 2009, 21:18:59

missed any connectors on reassembley?


read fault codes?  may just point you at whats wrong  :y

Title: Re: V6 not starting
Post by: barclay03 on 25 September 2009, 21:23:19

i dont think i did, but by the end of it all i just put the tools away, will check again when im refreshed tomorrow lol havent read the fault codes yet either but thats on the to do list before pulling it apart again  :y

Title: Re: V6 not starting
Post by: Jimbob on 25 September 2009, 21:25:31

I'd read em for the peace of mind.

It'd keep me awake wondering what it was.

I'm sure it will be as simple as one missed connector somewhere.

fingers crossed for you.

 :y

I know looking with fresh morning eyes often helps though....I can stare at something all day when im tired and miss the bleeding obvious, that you spot 1st time when your fresh  :y

Title: Re: V6 not starting
Post by: barclay03 on 26 September 2009, 11:01:25

Just did paperclip test and came up with fault codes:

59   Intake Manifold Valve 1 Voltage Low
133   Intake Manifold Valve 2 Voltage Low

 :-/

Title: Re: V6 not starting
Post by: feeutfo on 26 September 2009, 11:10:08

something un plugged somewhere.
What engine is it?

Title: Re: V6 not starting
Post by: barclay03 on 26 September 2009, 11:12:56

X30XE

did a quick search for same codes and theres a few posts with people saying the wiring at the back of the inlet manifold wasnt plugged in right.. guessing that'll be the first thing to check?

Title: Re: V6 not starting
Post by: barclay03 on 26 September 2009, 12:42:39

just took the plenum off and checked the wiring - everything appears to be connected  :-/

Title: Re: V6 not starting
Post by: irratic on 26 September 2009, 12:59:08

if its firing now and again check you've not got your plug leads wrong way round...

Title: Re: V6 not starting
Post by: barclay03 on 26 September 2009, 16:19:02

Well, found the reason for it not starting!

Stripped it all back down and cam 1 was on the wrong timing mark?!  :o dont remember doing that... so ive put them all bang on the timing marks and she started up first time.

Running fine, however my EML is flashing whilst its running and still throwing up the same intake voltage codes at me but all the plugs for intake are in fine?... any thoughts on it?

cheers  :y