Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: raywilb on 13 November 2009, 11:14:20

Title: code 19- td
Post by: raywilb on 13 November 2009, 11:14:20

code 19 - incorrect rpm signal. this code has popped up on a pc test. can somebody please enlighten me of the cause & cure . thankyou. :)












7

Title: Re: code 19- td
Post by: batista on 13 November 2009, 16:35:13

i thought code 19 is crank sensor,, :-/ i may be wrong

Title: Re: code 19- td
Post by: Pitchfork on 13 November 2009, 17:20:13

Quote

i thought code 19 is crank sensor,, :-/ i may be wrong

Remember it's a Weazle!!
Do Traktors have different codes?

Title: Re: code 19- td
Post by: Jimbob on 13 November 2009, 17:25:54

all Diesel codes here...

http://www.omegaowners.com/forum/YaBB.pl?num=1205270870

so yes, crank sensor

Title: Re: code 19- td
Post by: raywilb on 13 November 2009, 17:58:21

my tractors starting & running ok, can i expect it to nack up, & where is the crank sensor situated. ?  :y

Title: Re: code 19- td
Post by: damage consultant on 13 November 2009, 18:50:44

i'm sure the crank sensor job is a front end off job correct me if i'm wrong though :-/.
Try putting a 6mm earth direct from battery to ecu and see if it runs any better.

Title: Re: code 19- td
Post by: TheBoy on 13 November 2009, 19:18:11

if it is the sensor, it can be done from underneath, but easier to remove intake and starter...

Title: Re: code 19- td
Post by: raywilb on 13 November 2009, 19:54:44

i had the intake & starter off last weekend could i have disturb something.

Title: Re: code 19- td
Post by: Omegatoy on 13 November 2009, 20:26:10

crank sensor is just the starter motor aND FIDDLING AROUND doing starter IT MAY BE POSSIBLE TO KNOCK THE CONNECTOR  although it does have a clip you have to push to release it, more likely that you have leant or levered against it without knowing and damaged or dislodged the connection