Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: GBS100 on 09 December 2009, 14:02:23
-
hi i need to change the front wing on my 1996 gls saloon .does anyone know how bad a job this is.
-
just bumper off light out undo bolts, take wheel off undo the plastic wheel arch, undo the bolts, may need to pop the spot weld near the A frame if it was welded, then have to put flat screw driver in the gaps to pull off the wing as tere is sealent inbetween the wing and fame. :y
-
Another job I need to do soon to replace my drivers side front wing....so now i know how ! Thanks ;D
-
just bumper off light out undo bolts, take wheel off undo the plastic wheel arch, undo the bolts, may need to pop the spot weld near the A frame if it was welded, then have to put flat screw driver in the gaps to pull off the wing as tere is sealent inbetween the wing and fame. :y
i didnt with the four ive removed. :-?
-
I took one off six months ago and I'm sure my bumper stayed on.
Is there a weld?
-
There's a bolt/self tapper at the bottom of the A post that's visable when you open the door.
-
just bumper off light out undo bolts, take wheel off undo the plastic wheel arch, undo the bolts, may need to pop the spot weld near the A frame if it was welded, then have to put flat screw driver in the gaps to pull off the wing as tere is sealent inbetween the wing and fame. :y
i didnt with the four ive removed. :-?
mine has strutes from wing to the bumper, held on by 2 10m bolts, and there is 2 spot welds on A frame 3inc apart holding the wing on on both sides.
-
Early (94/95) wings are slightly different.