Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: unlucky alf on 16 February 2010, 12:18:48
-
o,k i received my replacement injector this morning, the problems ive got is: 1/ its got a black plug & mine is white. & 2/ the locating lug on the new one is in a different position, other than that the plug looks the same as the pins are marked up 1&2 the same as mine, is there a reason why the plug setup has been changed or can i just cut the locating lug off so it goes in. :-/
-
You should, if very careful with a pin, be able to remove the plug cover and swop it over to the original so it fits properly.
-
i did think of that welung but the wires are well sealed in the top of the plug, ive cut the lug off the plug now & marked the plug so i get it the correct way round, it still bugs me why the plug is slightly different, im just hoping its vx being awkward & not the fact that maybe the chip in the injector is set up differently, oh well id better go & try it, time to get my arm cut to bits getting it to plug in as its a swine to get to. :o :o :o
-
I guess you have the pre-maf diesel setup....
-
I guess you have the pre-maf diesel setup....
yup you got it mark,do you know if the plug is the only difference between the two? it plugged in o,k after lobbing the lug off the plug & it starts & runs o,k,so please tell me other than the plug they are the same injector,,,,cheers :y :y
-
Well, given its only a piezo transducer you are probably ok...should work fine
-
I had the same issue and trimmed the lug off. Been running it for about 2 years now, no problems. :y
-
I guess you have the pre-maf diesel setup....
yup you got it mark,do you know if the plug is the only difference between the two? it plugged in o,k after lobbing the lug off the plug & it starts & runs o,k,so please tell me other than the plug they are the same injector,,,,cheers :y :y
yip injector the same :y