Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: unlucky mark mv6 on 20 February 2010, 12:43:00

Title: selector switch removal help asap
Post by: unlucky mark mv6 on 20 February 2010, 12:43:00
Got the jacked up at the moment to remove it,but aint got a f*****g clue as to what i am doing to be honest.Is there two 10 mm bolts holding it?,and whats the bigger nut,it looks like a 15mm,do i need to remove this.Dont really seem possible to me to take it off without stripping half the underneath.Also when it says remove the heatsheild,which one?,is it the tin one where the wiring follows it behind. :-/
Title: Re: selector switch removal help asap
Post by: star_whites on 20 February 2010, 13:19:55
Been a long time since I did my selector but as I remember the heat shield is a metal shield that is held in place by 4 clips two on either side of the switch. Its actually the same shape as the switch itself. Once removed it makes it easier to remove the securing bolts for the switch itself.  :y
Title: Re: selector switch removal help asap
Post by: Varche on 20 February 2010, 13:38:44
If you like I could Email you some pics of my spare gearbox and switch so you can get an idea.

If yes pm your Email address.
Title: Re: selector switch removal help asap
Post by: Gaffers on 20 February 2010, 13:42:38
Or if you fancy a drive come down to Farnborough, done a few before :y
Title: Re: selector switch removal help asap
Post by: unlucky mark mv6 on 20 February 2010, 13:47:48
Thanks for the replies folks,but actually got it off now.Thanks again. :y