Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: kawijohn on 24 February 2010, 21:49:10

Title: heater matrix
Post by: kawijohn on 24 February 2010, 21:49:10

hi new to this site... iwas wonderin how you get the heater materix out of a n reg 3.0l v6 elite omega..... i have the dash just about out... but im havin a problem gettin the dash out. i know on mk3 astra you have three boults under the scuttle panel through the bulk head...howwever most upset to find this is not the same or at least i cant see any lol  :-? if any1 can help with either previous knowledge photos or the like plz get in contact need to figure out doin ma head in lol  ;D
thanks john :y

Title: Re: heater matrix
Post by: Entwood on 24 February 2010, 21:51:33

This might help .. from the "guides" section .. :)

http://www.omegaowners.com/forum/YaBB.pl?num=1262554909

Title: Re: heater matrix
Post by: Bionic on 25 February 2010, 08:46:58

Sent you a PM cos I am in the middle of doing mine, just on putting the new one in today.
Wish I had not used the Maitenance Guide! :D
Read the PM before you start anything else.
GudLuk

Title: Re: heater matrix
Post by: alank46 on 25 February 2010, 08:52:22

Hi
Could you send the PM to me too please as I am just about to start this job.
Thanks
Alan

Quote

Sent you a PM cos I am in the middle of doing mine, just on putting the new one in today.
Wish I had not used the Maitenance Guide! :D
Read the PM before you start anything else.
GudLuk

Title: Re: heater matrix
Post by: The Red Baron on 25 February 2010, 09:12:38

making a few cuts in the dash is much easier & you cant see it that much when its done. :)
i wouldnt be taking a dash out tbh.

Title: Re: heater matrix
Post by: kawijohn on 25 February 2010, 19:46:12

sorry lads but i aint doin no cuttin at all lol like i said everythin is off the dash but jus cant get the dash to pull forward seems there is somethin else holdin it  : >:(

Title: Re: heater matrix
Post by: Bionic on 26 February 2010, 03:52:49

Hi m8,
Don't blame you for not wanting to cut it either, I wish I never had, one thing certain I will never do any cuts again cos now I need a dash because even the sight of the hairline craftknife cut is too obvious for me. Yes, before anyone criticises me I took all the time (hours) and care possible.
See my PM, there are a few good helps in it you might like to try.
GudLuk