Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: Missy_MV6 on 03 April 2010, 22:16:53
-
Hi,went to look at an early facelift MV6 today and the wipers are sat approx a quarter way up the windscreen.The owner said they were fine until after he had been down the motorway..When you switch them on it wipes fine but then they come to rest too far up..Will it be a simple fix ??
Angie xx
-
should be, had this myself, nut comes loose on wiper motor, snow on the screen forced mine round, remove scuttle, loosen nut on wiper motor, set wipers in correct position re tighten nut.
-
.....Will it be a simple fix ??
Angie xx
Yes and at no cost. Remove the whole wipr assembly, 3 or 4 sel tappers, be carefull of the paint on your drriver's wing. Fastened to the wiper motor itself is an arm. This arm converts the rotary motion of the motor to a backwards & forwards motion of the wipers them selves. The nut that holds the arm on the motor has come lose. If you look, you'll see > < on the casting below the arm. The arm should sit bewteen these marks when parked. I replaced the nut with a selflocking nut (nyloc) only because I had a box full. :y
-
:)Thanks for the super quick reply,that sounds like an easy fix (for a change ;)).Picking the car up tomorrow so will give it a go.
Thanks Angie xx
-
should add, small arm to motor will need to be prized off motor spindle before the wipers can be reset, no biggy though.
-
....
snow on the screen forced mine round .....
You mean you didn't clear the screen first ::) ::) ::)
-
should add, small arm to motor will need to be prized off motor spindle before the wipers can be reset, no biggy though.
Prised off? The nut's come loose allowing the arm to spin on the splined taper, it won't need much prising ;) ;) ;)
-
should add, small arm to motor will need to be prized off motor spindle before the wipers can be reset, no biggy though.
Thanks going to pick it up at lunchtime tomorrow so will sort it out when it arrives at home :)
-
should add, small arm to motor will need to be prized off motor spindle before the wipers can be reset, no biggy though.
Prised off? The nut's come loose allowing the arm to spin on the splined taper, it won't need much prising ;) ;) ;)
speeking from experience. Yor post is more helpfull if its first time hands on in that area, i didnt remove the assembly though, but what ever works for you.