Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: griffin on 04 April 2010, 09:50:07

Title: 1612 fault code
Post by: griffin on 04 April 2010, 09:50:07

Hi All

Can anyone help/advise. Not used the car since last weekend but when I statreted it this morning it was very hesitant and started roughly. Once started seemed to drive ok thought I'd do a peddle check and came up with the following 1612 code.

problem/solution

TIA
 :)

Title: Re: 1612 fault code
Post by: Welung666 on 04 April 2010, 09:58:24

1612 is immobiliser, no or wrong signal.

Title: Re: 1612 fault code
Post by: griffin on 04 April 2010, 10:15:00

Thanks for the info. Is there anything I can do to rectify?

Title: Re: 1612 fault code
Post by: feeutfo on 04 April 2010, 10:42:59

would this be a case of a loose transponder in the key? never had this fault so see what others say.

Title: Re: 1612 fault code
Post by: Welung666 on 04 April 2010, 11:02:15

Quote

would this be a case of a loose transponder in the key? never had this fault so see what others say.

That would be my first check, followed by popping the steering cowelling off the check the receiver ring is still in situ and fully plugged in.

Title: Re: 1612 fault code
Post by: TheBoy on 04 April 2010, 11:07:11

think code unrelated to symptom

Title: Re: 1612 fault code
Post by: griffin on 04 April 2010, 12:39:20

Thanks guys, just coinsidence about poor starting. The speedo, rev and mig panel were removed beging of last week so that may be the cause possibly.

 :)

Title: Re: 1612 fault code
Post by: griffin on 04 April 2010, 16:43:50

May be a stupid question but I've taken the steering cowelling off (top section) but not sure what I'm looking for.

Sorry!!

Title: Re: 1612 fault code
Post by: griffin on 06 April 2010, 11:17:24

Morning!

Checked everything and all seems to be intact, do I need a tech2 to reset the codes etc?

Thanks for any advice.
 :)