Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: Vamps on 12 June 2010, 21:25:07
-
Can this easily be replaced?
-
Seek and yee shall find http://www.omegaowners.com/forum/YaBB.pl?num=1214169060
-
Seek and yee shall find http://www.omegaowners.com/forum/YaBB.pl?num=1214169060
Thanks for that..... :y
But can it not be replaced without doing all that, it is in the lid after all, can't see why you have to pull the whole lot out......... :-/ :-/ or have I missed something ::)
-
Seek and yee shall find http://www.omegaowners.com/forum/YaBB.pl?num=1214169060
Thanks for that..... :y
But can it not be replaced without doing all that, it is in the lid after all, can't see why you have to pull the whole lot out......... :-/ :-/ or have I missed something ::)
Yep, If you wanna break the new one in the process :D
-
Vamps...I thought exactly the same...and is the sole reason I ended up buying 2 handles :-[ and then writing the guide ;D ;D ;D
-
Its not that bad a job to do Vamps, slightly fiddly but not the worst of jobs.
If you dont fancy replacing the handle you could replace the whole glove box. Daft Lo Knee might be worth a try, I had one from him a while back. :y
-
I've been putting off doing mine for the same reason but I'm sure once I find the motivation, it won't be as bad as it looks.
The Carlton one were a doddle to change by comparison! And they didn't rattle all the blinkin time either!
-
Thanks for the reply's.....not buying this car now though............. :)