Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: markspark on 03 July 2010, 22:16:52

Title: this will be a quick on i hope help please
Post by: markspark on 03 July 2010, 22:16:52
hi all i have just bought a 2.2 dti and the external temp sensor dont work but i can't find it where is it on a facelift 2.2 dti
TIA
Title: Re: this will be a quick on i hope help please
Post by: Andy B on 03 July 2010, 22:19:23
Quote
hi all i have just bought a 2.2 dti and the external temp sensor dont work but i can't find it where is it on a facelift 2.2 dti
TIA

middle of the bumper, lower edge - visible on yours when you lift the bonnet & look down  :y
Title: Re: this will be a quick on i hope help please
Post by: markspark on 03 July 2010, 22:49:01
i have looked there only things i ca see are on the washer bottle ive had a feel around and cant feel any other wires or connectors that are small enough to fit the temp sens
Title: Re: this will be a quick on i hope help please
Post by: RobG on 03 July 2010, 22:54:04
centre of the lower grill
Title: Re: this will be a quick on i hope help please
Post by: markspark on 03 July 2010, 22:58:11
i shall have another look in the mornin thanks guys :y
Title: Re: this will be a quick on i hope help please
Post by: RobG on 03 July 2010, 23:02:44
On the facelift the connector end of the sensor is under the bumper in front of passenger side wheel. If you locate that just follow the wiring and you will reach the actual temp sensor
Title: Re: this will be a quick on i hope help please
Post by: markspark on 06 July 2010, 15:15:19
update i have now found the temp sensor it was plugged into random hole on chasis  on n/s of the car it has been tampered with at some stage the wires will not reach the hole in middle of the bumper, the sensor wires have crimped spade terminals on them slotted in to plug with 4 wires in it 1,bule/white 2,blue 3,black, 4, brown the sensor looks like it was connected to the two blue wires is this correct ? one of the pins in the 4 pin plug has rusted off and cannot be conected hense no temp reading on the mid. If connection is to the blue wires what are the black and brown for would it be ok to just cut off the plug connect whats needed and isolate the other two ?
TIA