Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: nonames on 16 July 2010, 13:40:38

Title: prop shaft centre bearing advice
Post by: nonames on 16 July 2010, 13:40:38

Ive got a problem with my 2.2 manual sometimes juddering when pulling away (hopefully its not the clutch as ive had it replaced recently i had this problem before it was done)
i think its caused by the prop shaft seal split making the bearing dry.

if it is the centre prop shaft bearing would i just need to replace the seal and gaiter and regrease using a grease gun?
its been like this for a while now and now i have a new clutch and i dont want to put extra wear on it!


any help would be great

Paul

Title: Re: prop shaft centre bearing advice
Post by: hoofing it on 16 July 2010, 16:06:05

To replace the bearing you need to take the prop and bearing fixings off. these have to be pressed off and on.
have you tryed moving the bearing/prop by hand,just grab prop and give it a good wiggle you should see any wear  :y