Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: blue_dream on 23 September 2010, 14:21:56
-
Morning guys
Have been asked by a friend of a friend to have a look at his 1998 25 v6, car will start but not hold idle, ok checked and cleaned idea valve, no good, replace with a know good one mine, still no good, checked air mass and swapped, still no good.
Checked the fault codes which shows cranksencer fault not to sure if old fault, but i thought car would not start if fault cranksencer was at fault :-? :-?
Any ideas guys before we start wasting money :y
-
Do the basics first......check for air leaks (pay attention to the brake servo hose)
Also worth blanking the EGR to rule that out.
-
Ideally clear the codes and see if the code returns, then you know it's current, but obviously a code reader capable of clearing codes is needed, which may cost at a garage if you don't have one.
-
20 to 30 starts of the engine should clear the code if it is an old one. :y