Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: Vicky on 23 November 2010, 11:41:43
-
my lovely omega elite has developed a problem just wondered if anyone could help, basically my seat wont move (drivers electric) i press the buttons on the seat and there is a clicking noise but no movement? i only wanted to move it a little but nothing, its a pain.... know you lovely people will have an idea, ive checked the fuse it had blown but ive changed it (yes i did change it on my own) but still no movement :-/
-
a good bet is to check the seat runners for coins jamming it.
I beleive there is a manual winding method too for if it gets stuck.
-
:-* ohh money in my car must be xmas... never even thought of that, will have to go on a rummage...
be interested in the manual movement, any clues........???
-
:-* ohh money in my car must be xmas... never even thought of that, will have to go on a rummage...
be interested in the manual movement, any clues........???
http://www.omegaowners.com/forum/YaBB.pl?num=1163236766 :y
-
:-* ohh money in my car must be xmas... never even thought of that, will have to go on a rummage...
be interested in the manual movement, any clues........???
http://www.omegaowners.com/forum/YaBB.pl?num=1163236766 :y
Thats for all omega up down seats, theres another one for front to back... Elite's did come with a special 'windy tool' for the job, but are like hen's teeth I beleive.
-
http://www.omegaowners.com/forum/YaBB.pl?num=1240534535/1#1
describes what you are looking for, sure theres a photo somewhere...
-
Got it, the user manual
http://www.omegaowners.com/forum/YaBB.pl?num=1232026151
page 67 :y
-
thankyou so much couldnt drive the miggy in my new boots without moving the seat just a fraction was doing my nut in.... thankyou!!!!! :y
-
No worries, gets your seat moved even if there is a power / motor problem.
-
No worries, gets your seat moved even if there is a power / motor problem.
not if there's a coin stuck in the runners ::) ::) :y
-
:-* ohh money in my car must be xmas... never even thought of that, will have to go on a rummage...
be interested in the manual movement, any clues........???
http://www.omegaowners.com/forum/YaBB.pl?num=1163236766 :y
Thats for all omega up down seats, theres another one for front to back... Elite's did come with a special 'windy tool' for the job, but are like hen's teeth I beleive.
... in which case a hen's tooth is just like a length of 5mm diameter steel rod with one end filed down to a 4mm square section and a crank formed on the other end. The square section is about 15mm long. The crank is about 125mm from the business end and has a throw of 25mm.
Should be easy enough to knock one up if you don’t have one. :y