Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: Boditza on 27 November 2010, 17:11:02
-
My sunroof wasn'r working at all and i got from scrap yard a motor and ecu, but its driving me crazy. i tryed to reset it as it was sayd in tis but no luck from the first step.
on the colose position i am supose to push the button untill the sunroof comes to a stand and its completely closed but it doesn't, it tilts up about half way. if i tilt up at max it tilts stays there 2-3 secs(some clicks can be heard) and it comes down about half way of the tilt position. if i turn the knob to full open it opens perfect but when i close it it slides to closed position then opens again :o. it is driving me crazy
this is what tis says
Motor (Gears, Control Unit), Adjust
Adjust
Ignition on.
Calibration run
1
Hold preselector switch rotary knob down until motor comes to a standstill. Cover (glass) cover is in closed position.
First
Learning run
2
Preselector switch rotary knob to lift – roof tilts.
3
Preselector switch rotary knob to closed, hold pressed until roof closed.
Second
Learning run
4
Preselector switch rotary knob to open – roof opens.
5
Preselector switch rotary knob to closed, hold pressed until roof closed.
Caution
If the roof opens automatically after a closure command (points 3 and 5), repeat points 2 to 5 (1st and 2nd learning runs) by up to three times.
-
I think its...get fully open. push switch up for 10 seconds. close... push up for 10 seconds. get to full tilt .....push up for 10 seconds
-
i'll try it then reply back. tx
-
Reset is simple...
Push up in full open position for about 7-8 seconds (gives it time to fully open plus about 2-3 seconds)...then 7-8 seconds in the full tilt position then 7-8 seconds in full close position...job done
-
Reset is simple...
Push up in full open position for about 7-8 seconds (gives it time to fully open plus about 2-3 seconds)...then 7-8 seconds in the full tilt position then 7-8 seconds in full close position...job done
when i open it i keep the button pressed and in 2 secs after it opens completely it starts to close :( and it goes to half tilted pozition wich is basicly its closed position :(
-
have you looked at this? ...... it might help :-/ http://www.omegaowners.com/forum/YaBB.pl?num=1247486519
-
have you looked at this? ...... it might help :-/ http://www.omegaowners.com/forum/YaBB.pl?num=1247486519
I looked at it and thats what might have ruined my original sunroof ecu.. :( because i didn't knew how to assemble it back :-[. can you please tell me how do i know i closed the sunroof manualy, i mean what signs should i look for?? what is best to use to manualy close it because i use a flat screwdriver and it doesn't fell like its the right thing.
-
Yes flat blade screwdriver, push up then turn.
-
i turned but it doesn't seem to have a point to stop when its completely closed to stop turning or something :(
-
... but it doesn't seem to have a point to stop when its completely closed to stop turning or something :(
it doesn't, just wind it till it is level with the roof. The stop positions are built into the motor/ecu :y :y
-
ok.. thank you for your help with this.. hope i will sort it out eventualy
-
sorted... for further users take off the mechanism with ecu and motor and press the knob untill it stops then insert it into the sunroof.
-
Well done. :y
-
Well done. :y
:)likewise