Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: greenfingers 79 on 20 June 2011, 22:34:03
-
as is says, had a warning on the dash, the tank was only 2/3rds full, havent noticed any leak anywhere, could this be a un seen problem?
topped the tank up with tap water but am asking how to drain the system and what to re fill with,
any advise welcomed
-
Which engine mate - makes a difference ;)
-
If its a V6 then the sensor on the header tank is probably sticking...take the cap off the tank and push the plunger up and down a bit...worst case a new header tank with sensor is only about £40...
Should be topped up with 50/50 Vaux pink antifreeze and water mix
-
its a 2.2dti,
is there a how to to drain the system or is it just a case of pulling the bottom hose off the rad and letting it drain that way?
-
If you look underneath the front of the car from just in front of the n/s wheel you will see the bottom of the radiator. There is a drain plug there for draining the system. You will only drain about half the water from the engine.
-
If you do drain half, you can then fill with water, take it for a spin and then drain again. Do this again a few times and only a small % of the original stuff will remain.
You should also flush/reverse flush the heater matrix whilst you are at it.
-
sound for the advise, what do i refill the coolant system with, any recomendations and how do i flush the heater matrix????
can someone help with any pics of both jobs please
-
sound for the advise, what do i refill the coolant system with, any recomendations and how do i flush the heater matrix????
can someone help with any pics of both jobs please
-
Which engine mate - makes a difference ;)
what are the differences?? :y