Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: valliant72 on 05 August 2011, 19:51:52

Title: Torque control signal
Post by: valliant72 on 05 August 2011, 19:51:52

Hi just check the gearbox for codes using "My Naff Code Reader", fortunately there  was none. I did the output test on the torque control signal, it kept changing from active to inactive when i run the test. is this normal or a problem somewhere?

Title: Re: Torque control signal
Post by: Jimbob on 05 August 2011, 20:43:29

"My Naff Code Reader" actuator tests are a bit flaky to say the least...

it may or may not be doing something. you need to listen to the car, can you feel anything happen?

it may....it may not, which could be down to the car, or "My Naff Code Reader".

I reckon you prob wouldnt notice anything without the box in pieces. or checking voltage at the terminals in question etc.

Title: Re: Torque control signal
Post by: valliant72 on 05 August 2011, 20:56:52

Oh i see, thanks for your reply. :)