Omega Owners Forum
Omega Help Area => Omega Electrical and Audio Help => Topic started by: bogit on 21 May 2007, 08:44:02
-
ok ive striped the loom back to the drivers foot wel. all sills up.
the conecter block in front of the centrel locking ecu,how do i remove it ?
do i have to pull the wheel arch liner out and fiddle behind the carbon collecter thingie ?
or in other words how did you get to this stage.
(http://i42.photobucket.com/albums/e327/n0ddy/miggy/c0ac2706.jpg)
the loom from the foot well up to stereo is it the same for bose and non bose ?
or do i have to replace the whole stereo loom hu to amp ?
this seemed like a good idea a few weeks ago :)
-
the bracket (bottom left of that picture) is fixed over the top of the central locking controller by two plastic nuts, 10mm comes to mind ... remove those (one either side of the controller) and the bracket lifts off, the speaker wiring loom connector clips into the bracket.
-
hes right ya know :)
-
The dash loom is the same.....so this can stay!
-
you have no idea how glad i now feel now that i know that :) :)
-
Dam, should have lied and told you to chuck it all in a box and ship it to me.....
-
and then i found the loom for the carin crap nav.
earth,switched fused live. 1 small multi plug and goes into the 2 enormous multi plugs in the passenger foot well. hhhhhhhhhmmmmmmmm
-
Dam, should have lied and told you to chuck it all in a box and ship it to me.....
Nah, I would have gone and picked it up ;)
-
to late its fitted now :)