Omega Owners Forum
Omega Help Area => Omega Electrical and Audio Help => Topic started by: Don_Semo on 12 October 2008, 16:15:00
-
Hi everybody. I foun a cable that i don't know what is for. Hope someone can tell me.
Here is some pics
(http://media.snimka.bg/0956/008166786.jpg)
(http://media.snimka.bg/0956/008166789.jpg)
(http://media.snimka.bg/0956/008166767.jpg)
Hope you see it.
-
Heated washer jets maybe?
-
It's not for the washer jets. The washers are already connected and working.
Other opinion?
-
I was going to suggest heaters for washer jets as well :-/
-
Being LHD could the Power Sounder be on that side? If so the I guess Power Sounder feed!
-
Power Sounder?
Brake master cylinder is on the wrong side :o
-
The power sounder (the alarm speaker i gues) is on the same side but it is connected too.In my case the driver is on the left seat. [smiley=wink.gif] .My "default" alarm is working properly too. Correct me if i'm wrong. What could it be for.
-
Might be a good idea to post a picture of the entire engine bay so we can see where everything is on your car as obviously most people on here are used to looking at RHD cars :)
-
What about a 'spare' crank sensor? Rather than puling an old sensor out, the fitter might have just left the old one in place & fitted the new one. IIRC we found a similar plug at the back of Ian_D's engine ..... that's what we put that down to - cos we couldn't think of owt else :-/ ;)
-
It's done mate. It's an old picture and everything is a little bit dirty but I hope it helps a little.
(http://media.snimka.bg/1008/008271268.jpg)