Omega Owners Forum
Omega Help Area => Omega Electrical and Audio Help => Topic started by: Tornado632 on 14 October 2010, 18:26:19
-
Hi Guys
Just changed my exhaust down pipe on my 1999 20l 16v ecotec Automatic, started the car and it ran rough for a bit but now its ok, but the engine managment light is staying on... Can I bring up the flash codes by using the paper clip trick or is my car too new! I seem to have two diagnostic plugs, one in the main fuse box and one next to the servo unit, can anyone tell me which is the correct one.
-
Yes, and its one under steering wheel.
The one on suspension turrent isn't a diag connector, its the cruise control loom.
-
As TB says you can paperclip it, instructions are below :y
-
Hi
Thanks for the info, but no Instructions came through...
Cheers
-
have you checked that you've not disturbed any connectors possibly the lambda sensor as you've been working nearby :-/
-
Hi
Yes I have, when I first started the car after fitting the exhaust is was runing badly, but now its runing ok so I think the fault is gone but still stored in the ECU and only need to be cleared to put the light out..
-
Hi
Thanks for the info, but no Instructions came through...
Cheers
His instructions for the paperclip test were in his SIGNATURE ;-)
Heres the link :- http://www.omegaowners.com/forum/YaBB.pl?num=1189022687
-
Hi
Thanks for the info, but no Instructions came through...
Cheers
His instructions for the paperclip test were in his SIGNATURE ;-)
Heres the link :- http://www.omegaowners.com/forum/YaBB.pl?num=1189022687
Eyes wide shut! ;) :P ;D ;D