Omega Owners Forum

Chat Area => General Car Chat => Topic started by: Webby the Bear on 19 February 2012, 21:55:11

Title: Anyone know anything about Pug 307 servicing?
Post by: Webby the Bear on 19 February 2012, 21:55:11
Hi ya, as above really. Since starting my grease monkey antics one of my mates wants to come over to tinker on my engine  :o :D :D

I said ''sure bro, you can help me with my cambelt change''  ;D and he was like ''yeah sounds good''  ::) ;D ;D ;D ;D

However, he did say do you reckon you could show me how to service my 307 (1.6 petrol). ''Errrrrm'' I said. ''Not sure''. I said I'd look in to it.

So having looked in to it I've registered on there site and they're fairly useless TBH.  ::)

I've found out the pollen filter is got at by removing scuttle, pulling handle on a draw and removing/replacing. Fine.

Apparently air filter is in an odd place too. Anyone know?

I've also found out that it's a coil pack but sounds a lot easier than the coil pack removal for the mig (in the guide) as I think it's undo clips on the cover, remove coil pack, replace as normal.

Anyone got any further info that will help my mate?  :y

Cheers all  :y
Title: Re: Anyone know anything about Pug 307 servicing?
Post by: tidla on 19 February 2012, 22:03:35
close the bonnet and step away from the vehicle :)

what year and mileage on the pug?
Title: Re: Anyone know anything about Pug 307 servicing?
Post by: Psychoca on 19 February 2012, 22:26:36
close the bonnet and step away from the vehicle :)

I was thinking a sledgehammer!!!
Title: Re: Anyone know anything about Pug 307 servicing?
Post by: Webby the Bear on 19 February 2012, 22:28:40
close the bonnet and step away from the vehicle :)

what year and mileage on the pug?

Haha I did tell him ''there's no point as it is shit''  ;D ;D ;D

It is very low mileage (40k-ish) and is on a 53 plate  :y
Title: Re: Anyone know anything about Pug 307 servicing?
Post by: Webby the Bear on 19 February 2012, 22:44:50
Hahahahaha just had some retard on the 307 forum post:

Yes here's a link that will help... and then put up the Haynes manual. Pointless forum.

Although maybe I'm spoiled with OOF  :y :y :y :y
Title: Re: Anyone know anything about Pug 307 servicing?
Post by: bored bigyin54 on 19 February 2012, 22:45:51
pug's are crap steve
Title: Re: Anyone know anything about Pug 307 servicing?
Post by: adey2 on 19 February 2012, 22:47:53
have the electrics lasted that long without giving up the ghost
Title: Re: Anyone know anything about Pug 307 servicing?
Post by: omega3000 on 19 February 2012, 23:01:28
Hi ya, as above really. Since starting my grease monkey antics one of my mates wants to come over to tinker on my engine  :o :D :D

I said ''sure bro, you can help me with my cambelt change''  ;D and he was like ''yeah sounds good''  ::) ;D ;D ;D ;D

However, he did say do you reckon you could show me how to service my 307 (1.6 petrol). ''Errrrrm'' I said. ''Not sure''. I said I'd look in to it.

So having looked in to it I've registered on there site and they're fairly useless TBH.  ::)

I've found out the pollen filter is got at by removing scuttle, pulling handle on a draw and removing/replacing. Fine.

Apparently air filter is in an odd place too. Anyone know?

I've also found out that it's a coil pack but sounds a lot easier than the coil pack removal for the mig (in the guide) as I think it's undo clips on the cover, remove coil pack, replace as normal.

Anyone got any further info that will help my mate?  :y

Cheers all  :y

 ;D :-X :y
Title: Re: Anyone know anything about Pug 307 servicing?
Post by: Webby the Bear on 20 February 2012, 20:21:44
Seriously guys.... I just logged on to the 307 forum hoping that there may be some helpful responses posted between the time I logged off and logged back on again this evening. I posted specific Q's in a very polite manner and got 2 utter retards (in addition to the Haynes w--ker) saying ''errrm yeah defo different engine to yours'' hahahahahahahahaa WTF And the answers to my basic Q's???

God bless OOF!!!!