Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega General Help / Re: is my car dead

« on: 18 April 2010, 10:34:53 »

hi no oil in water, oil is very black and a smell of petrol in the header tank.. no mayo on dip stick.. water in header tank looks to be very dirty brown even after renewing it.. think it head gone myself..

2

Omega General Help / is my car dead

« on: 15 April 2010, 20:23:16 »

hi help needed but think i know the answer,,
my car has loads of white smoke coming from it, and it over heats very fast....loads of mayo in oil filler cap ..is it dead..
thanks pete

3

Omega General Help / Re: cam covers

« on: 01 November 2009, 15:10:09 »

did this a few days ago.. think its ok i`ve now put carboard so i can see where its coming from and it is just from the r/hand side must be alot when the car is driven there is a lot of smoke as it is burning on the hot plate below it (think these cover some oil pipes)

4

Omega General Help / Re: cam covers

« on: 01 November 2009, 14:50:45 »

all pin`s done up nice...8nm

5

Omega General Help / Re: cam covers

« on: 01 November 2009, 14:43:21 »

hi yes used all good stuff (vux)

6

Omega General Help / cam covers

« on: 01 November 2009, 14:36:56 »

hi all
had to replace cam cover gaskets.a few weeks ago but found it still leaking.. so got some more new gaskets and did again,,but still having same prob..oil coming out from r/h side,,, is it poss that the cam covers need to be replaced.. any idea`s thanks pete

7

Omega General Help / Re: cam belt

« on: 02 April 2009, 18:42:21 »

thanks for all the help will way up cost of all and see..
thanks again..pete

8

Omega General Help / cam belt

« on: 02 April 2009, 14:51:55 »

hi all
i am going to take on the cam belt in my v6 mog,, after i got the dvd from here on how to.. didnt seem that bad..can any one tell me where is the best place to get the locking tool to do the job.. or beeter still can some one help me out with it who already has one .. and i will pass on the beer tokens for this.. help need for the type of water pump i need to get and new cam belt..

 thanks pete

9

Omega General Help / Re: oil filler

« on: 25 March 2009, 15:36:58 »

ta very much...told you that simple..for some...

10

Omega General Help / oil filler

« on: 25 March 2009, 15:23:20 »

simple one but how do i get it off.. does it just pull away.. or by undoing the bolt ..which i will need to find one to fit in to the small hole..
thanks pete

11

Omega General Help / oil prob

« on: 13 March 2009, 12:42:51 »

hi all
i have just replaced the crank sensor on my car.. this is when i noticed oil coming from a small hole just above the oil flitter ??

any one got a clue has to wat this is..
ta.pete :-/

12

Omega General Help / part number

« on: 05 March 2009, 17:02:31 »

hi all
can any one give the part number for my x reg 2.5 v6 crank shaft sensor please..
ta pete

13

Omega General Help / Re: is my car dead...

« on: 02 March 2009, 20:56:17 »

it still comes out has being 1-2-1-2-1-2..9-1-2-9 but after 20mins my eyes went ,,so went to work will get the wife to look and shout it to me.may have better luck has i`am losing it,,,

14

Omega General Help / Re: is my car dead...

« on: 02 March 2009, 13:58:17 »

yes its on both lpg.and petrol..no mayo on dip stick..and tank is ok..

15

Omega General Help / Re: is my car dead...

« on: 02 March 2009, 13:40:56 »

thanks gents..i may not be reading the test right(re-the paper clip)
just looks to me to do 1-2-1 x3 then 1-2-9-1-2-9 x5 on so on till the end..there is no mayo on dip stick..so could it be the crank sen has you have said...hope so i love me car..ps dont do short runs, not less then 120 miles a day to work and back ..

thanks for the help..