Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Foxycav

Pages: [1] 2 3 4 5 6 7 8 ... 16
1
Omega General Help / Re: Heatshield death
« on: 23 April 2010, 08:11:29 »
Quote
Do you mean the big heatshields that are held on to the underside of the car with a series of 10mm nuts (I think there are four of them)

or do you mean the heatshields that are permanently attached to the exhaust downpipes? (one on each downpipe)

or do you mean the heatshields bolted top and bottom of the exhaust manifolds (two each side/manifold).

On my 1994 V6 the manifold heatshields rotted away first and I replaced them when I changed the headgaskets.

The heatshields on the downpipes disintegrated and fell off at about 190,000 miles. I bought some exhaust wrap to try to contain the heat but never got round to fitting it and the heat didn't seem to do any harm.....

I think the big heatshields are stainless steel, I can't imagine them rusting and falling off. I did have one fixing stud shear off when I adjusted the handbrake cable but there are so many fixings it didn't seem to matter....
OMG didnt realise there where so many :o :o
looking at the piece of pipe it looks like one of the exhaust downpipe ones. Ive been told that if i try to remove the peg its attached to i might end up with a tiny hole in the actual floor. Cos if its rusted its more than likely the peg will be (thus being a PITA to remove). I think i might leave it be. it didnt seem to effect the car on the way back home.

2
Omega General Help / Re: Heatshield death
« on: 22 April 2010, 21:01:35 »
Many thanks for that :y looks like one short piece has come off one side, it was a right mess (rust)so i will get them all checked out and replaced if needed. Thanks again for replying :y :y

3
Omega General Help / Heatshield death
« on: 22 April 2010, 18:08:32 »
Ive just been up to Yorkshire in the Omega and when i arrived, noticed the remains of a lovely rusty heat shield hanging from the car to the floor ::).
Question is i need to use my car again and was wondering if it would be ok to do so??? Plus any ideas where i can get a good one from.
ETA: can anyone tell me is there 2 Heat shields either side of the car, as looking on a part finding place it looks like there is ::)



4
Quote
Its all controlled by the elite seat settings. You program in upto 3 settings and the ECU remembers them, when you press one of the 3 buttons, the seat, external mirrors and internal mirror move to the preset setting. Dont think it will be possible to retro fit it so the motors work :(
Cheers Pete, thats what i wanted to know :y

5
Ive got my cdx but i was wondering if i fitted the dimming rear view mirror how would it be controlled?

As i looked in scrapyard and there was an elite in but no obvious way to control the mirror motor.

I know about wiring the dimming alone in but id like to have it working properly.

Is there any chance of the car being wired for it already.

6
oooo i'd best get some door bushes for my drivers door then :)

7
Omega General Help / Re: key fob....
« on: 06 March 2010, 21:54:19 »
Quote
Anybody know how to repair a key fob plz??? Both of mine have stopped working now....I can only use the key now  and everytime i open the doors the alarm goes off and only stops when i start the car up.... :-[

ditto , only ever got the spare key and now ive got to get that programmed, annoying to say the least ::)

8
Omega General Help / Re: how much is my car worth
« on: 04 March 2010, 15:30:36 »
Quote
they are borderline crooks as far as I understand.
exactly what i was about to say, a friend of mine did it with his Brooklands Capri (worth around 8k) and they offered him £150 :o :o. Needless to say he declined the offer

9
Newbie Welcome Area / Re: new member...
« on: 28 April 2010, 10:01:28 »
hello and welcome to OOF :y

10
Newbie Welcome Area / Re: Better late than never
« on: 06 May 2010, 22:31:19 »
welcome to OOF :y

11
Newbie Welcome Area / Re: Hi Guys
« on: 26 April 2010, 16:09:17 »
Welcome to OOF :y

12
Newbie Welcome Area / Re: Hello from V6 omega owner
« on: 30 April 2010, 20:29:58 »
welcome to OOF :y

13
Newbie Welcome Area / Re: Hello
« on: 19 April 2010, 20:21:55 »
Hello and welcome to OOF :y

14
Newbie Welcome Area / Re: hi there
« on: 13 April 2010, 20:52:26 »
hello and welcome to OOF :y

15
Newbie Welcome Area / Re: hello new here
« on: 08 April 2010, 16:21:41 »
Hello and welcome to OOF

Pages: [1] 2 3 4 5 6 7 8 ... 16

Page created in 0.008 seconds with 14 queries.