Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega Electrical and Audio Help / immobiliser problem.

« on: 14 August 2007, 17:51:58 »

help please.i cant  start my 2.5 elite,the eml keeps flashing on dash.the immobiliser has cut the fuel pump dead.how do i rectify this problem any idears

2

Omega General Help / how do you clear stored codes.

« on: 23 October 2009, 19:37:36 »

i have codes 0700 saying transmission control system (MIL request) and a code 0727 saying engine speed input circuit no signal..now ive changed the camshaft sensor for a genuine vauxhall one cost of £75 from vauxhall,,but the eml stays on with these codes still there,,anyone know how to get rid of these codes,,would be most appreciated,

3

Omega General Help / vauxhall oil filter part no. req

« on: 03 November 2009, 15:50:54 »

does anyone know the part number for a vauxhall oil filter for the 2.2 omega auto petrol engine is it VOF93 ? :-/

4

Omega General Help / part no. required

« on: 02 October 2009, 17:53:56 »

anyone know the correct part no. for the crank sensor on a 2.2 sport 02 reg mig.how much would one cost or has anyone got one forsale.cheers

5

Omega General Help / autobox fault code

« on: 28 May 2009, 17:42:38 »

ive a 2002 facelift 2.2 sport,with autobox code saying 0700.anyone know what this means i would be most grateful..

6

Omega General Help / fault codes need help.

« on: 05 October 2008, 18:52:25 »

had mate do the tech 2 on my facelift.the 1st code that came out was 0747...then he did the test again and 3 codes were registered saying 1781  0700  0747.any one know what these codes are,and how to fix them.most appreciated  

7

Omega General Help / autobox on 2.2 ecu

« on: 08 September 2008, 17:37:06 »

had eml for some time and got a computer check done on it think code said 0700,but it came across as the autobox ecu.if i buy a new one does it have to be programmed to the car i have an 02 reg 2.2 sport..it runs fine ,but once in a while it goes into limp,its ok going through the gears...

8

Omega General Help / autobox code 0700

« on: 28 June 2008, 19:30:04 »

eml stays lit all the time.car keeps going into limp mode,so took it to garage today and they said that theres a problem with the autobox ecu,it keeps coming up code 0700.he said that theres no power going to the ecu ,does anyone know why this can be.all answers much appreciated

9

Omega General Help / need part no.front wheel bearing & hub

« on: 27 June 2008, 21:56:17 »

does anyone know the part no. for the front wheel bearing and hub assembley,on a omega 2.2  02 reg...

10

Omega General Help / regarding paper clip test

« on: 17 May 2008, 17:21:19 »

hello all,can the paper clip test be performed on my 02 reg 2.2 sport omega. :-/ the eml has came on ,but stays on.

11

Omega General Help / [m by=TheBoy destboard=GenChat dest=1207244630]: problem with bros beammer

« on: 03 April 2008, 18:52:41 »

[moved] [link=http://www.omegaowners.com/forum/YaBB.pl?num=1207244630/0]General Chat[/link] [move by] TheBoy.

12

Omega General Help / brake light switch

« on: 02 April 2008, 19:36:56 »

pardon me for being thick but does anyone know how to get the brake light switch off the pedal bracket.bloody haynes manual waste of money....

13

Omega General Help / autobox problem

« on: 16 February 2008, 19:45:34 »

hello all,ive a 2.5 elite and the display is showing auto gearbox.so is there any experts out there know what wrong with it.i noticed that when warm it seemed to eg. i would touch the throttle and it wouldnt pick up but then it would pull off fast some times wheel spinning.could it be oil needs replacing or oil low.any comments gladly welcome.all gear changes are sound sports mode sound no problem. :-/

14

Omega General Help / paper clip test

« on: 13 September 2007, 18:36:56 »

hello fello omegas,my v6 elite idles eratically.just done paper clip test and code fault 59 is lit up,saying inlet manifold senor high voltage/low voltage.what does this mean,pardon me for being thick,is it knackered or something else wrong.any comments greatly appreciated.

15

Newbie Welcome Area / newboy

« on: 13 August 2007, 20:27:14 »

 hi all,my name is Darren i have 2 omegas 1 2.5 elite silver with all irmscher kit automatic,the other is a 2.0 cdx manual.both 1998.and i am a mad Elvis fan.....