106
Omega Electrical and Audio Help / Re: battery going flat
« on: 23 October 2012, 11:06:38 »
What about the Alternator have you had that checked?
Welcome to OOF
Handbrake backplates, about how much and are they vx only?
.....
It's not the cost of them, it fitting the bu66ers that's the hard part.
Right, I've dropped a bit of a block
Original design: rubber trim x2, 1 top and both sides, 1 across bottom edge. plastic frame x2, same as rubber.
Later design: rubber trim x2, 1 top and sides, 1 across bottom edge. plastic frame x4, 2 sides, 1 top, 1 bottom.
Only the rubbers are interchangeable
Pattern frames supplied by winscreen frames vary, but usually depend on the rubber being reusable.
Visible differences between two cars could be down to the various frames used and also the actual position of the glass depending on whether the screen is original/replaced properly in the correct position/just thrown in.
Either way the trims are available
Cheers
Right, I've dropped a bit of a block
Original design: rubber trim x2, 1 top and both sides, 1 across bottom edge. plastic frame x2, same as rubber.
Later design: rubber trim x2, 1 top and sides, 1 across bottom edge. plastic frame x4, 2 sides, 1 top, 1 bottom.
Only the rubbers are interchangeable
Pattern frames supplied by winscreen frames vary, but usually depend on the rubber being reusable.
Visible differences between two cars could be down to the various frames used and also the actual position of the glass depending on whether the screen is original/replaced properly in the correct position/just thrown in.
Either way the trims are available
Cheers
Pete does the rubber windscreen trim just pull off on your 2.2 and if so how much?
Its not a seal..its a trim...glass is bonded in with eurothane (thats the seal) trim is put on glass prior to fitting so sounds like you need a remove and refit of the screen with a new trim
May have been the Loch ness Monster looking for new surroundings in Glasgow and dropped in for a bite to eat
Best solution would be to buy a replacement battery holder and solder it in.
I keep meaning to find one that fits. I'm sure RS / Farnell will do one.