46
Omega Electrical and Audio Help / Re: bodging a wiper stalk
« on: 10 November 2008, 16:28:39 »
Right i have removed the plastic block of the new stalk, this was achieved by pressing the 2 small yellow tabs with a small screwdriver
![](http://i438.photobucket.com/albums/qq103/BigA11y/stalk003.jpg)
which will allow the small sockets on each wire to slide out, once they have been freed
![](http://i438.photobucket.com/albums/qq103/BigA11y/stalk005.jpg)
To release the sockets from the plastic holder follow NickA's advice highlighted by Welung666 and insert a pin of some sort down the hole towards the center of the plastic connector, this releases the tab locking the socket into the connector allowing you to push them out of the connector using a small screwdriver
![](http://i438.photobucket.com/albums/qq103/BigA11y/stalk007.jpg)
If it ever stops raining i will remove the existing stalk and continue the process
![](http://i438.photobucket.com/albums/qq103/BigA11y/stalk003.jpg)
which will allow the small sockets on each wire to slide out, once they have been freed
![](http://i438.photobucket.com/albums/qq103/BigA11y/stalk005.jpg)
To release the sockets from the plastic holder follow NickA's advice highlighted by Welung666 and insert a pin of some sort down the hole towards the center of the plastic connector, this releases the tab locking the socket into the connector allowing you to push them out of the connector using a small screwdriver
![](http://i438.photobucket.com/albums/qq103/BigA11y/stalk007.jpg)
If it ever stops raining i will remove the existing stalk and continue the process