76
Omega Electrical and Audio Help / Re: MID from auto to a manual
« on: 25 November 2008, 09:08:25 »Quote
i need a new mid my replacement one has dead pixles anyone got a 3.0 one???
i have one from a 99 mv6 fella
- 07 June 2024, 07:29:04
- Welcome, Guest
News:
Search the maintenance guides for answers to 99.999% of Omega questions
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
i have one from a 99 mv6 fella
77
Omega Electrical and Audio Help / Re: No fog lights
« on: 22 November 2008, 12:18:08 »
on the passenger hinge there is a plastic casing under that are the wires remove the plastic and you will see the wires
78
Omega Electrical and Audio Help / Re: No fog lights
« on: 22 November 2008, 11:45:27 »Quote
Dash works now - fuse 28 put back in
I think either later today or tomorrow I will trace the wire back to the boot.
What route does it take from the fuse panel to the LHS cable run?
down the passenger side
79
Omega Electrical and Audio Help / Re: No fog lights
« on: 22 November 2008, 11:30:34 »Quote
QuoteRelay still clicks
i will say it again broken wire at the passenger side hinge ! had two of them now :-?
80
Omega Electrical and Audio Help / Re: No fog lights
« on: 17 November 2008, 21:14:18 »Quote
Relay still clicks
i will say it again broken wire at the passenger side hinge ! had two of them now :-?
81
Omega Electrical and Audio Help / Re: No fog lights
« on: 16 November 2008, 23:34:53 »
broken wire kevin near passenger side boot hinge !
82
Omega Electrical and Audio Help / Re: car alarm
« on: 08 November 2008, 00:22:43 »
bonnet sensor tim ! mine was same few weeks ago ! dissconectted it to make sure then replaced with a spare
83
Omega Electrical and Audio Help / Re: Bloody Headlights :-(
« on: 18 November 2008, 20:46:00 »Quote
As an aside, you know those little RHD/LHD levers inside the headlights, which way should they be for RHD? I think one of my lamps may be the wrong way round
Humpy
pull upto a wall and see if you can see a kick up then try flicking lever makes the beam allmost flat ! you need to have the kick up
84
Omega Electrical and Audio Help / Re: Bloody Headlights :-(
« on: 18 November 2008, 13:55:37 »Quote
Totally different how Markey?? Not had any problems doing this before mate...works fine...
the adjusters inside the ribbed lights are toatally different and when you come to set lights up you carnt get the right adjustment on them !!
85
Omega Electrical and Audio Help / Re: Bloody Headlights :-(
« on: 17 November 2008, 22:28:56 »Quote
Well I managed to get my old headlights apart earlier and took the plastic adjusters out (which are still intact) and I will be attempting to put them in my projectors at the weekend if not sooner. So the idea is to heat up the lens to soften the mastic goo and the lenses should then come apart with ease?
Paul
dont work mate totally different ! have tried mesen sorry
86
Omega Electrical and Audio Help / Re: Bloody Headlights :-(
« on: 26 October 2008, 22:17:11 »Quote
Sounds daft but mines an elite so can i fit the xenon type then mate cause the projectors are better than the older type but not as good a xenon ones.......All i have to do is fit them right or is there more to it than that. :-/ :-/Quoteas long as the car stays level when loaded up xenons are fine ! i have converted 3 cars now and never had a problem come mot time !!
yep you certanly can dude
87
Omega Electrical and Audio Help / Re: Bloody Headlights :-(
« on: 25 October 2008, 18:39:41 »
as long as the car stays level when loaded up xenons are fine ! i have converted 3 cars now and never had a problem come mot time !!
88
Omega Electrical and Audio Help / Re: Bloody Headlights :-(
« on: 25 October 2008, 11:33:20 »
he drives a elite entwood so has the washer system and the self levelling on the rear so is fine with fitting hids (in the eye of the law) which is an arse !!!!
89
Omega Electrical and Audio Help / Re: Main Beam Bulbs
« on: 11 November 2008, 08:46:29 »
stick some hids in there ! h7 kits on ebay matey thinking of getting some 8-)