76
Omega General Help / Re: Reverse on a manual gearbox
« on: 12 March 2010, 14:24:37 »
I have a N reg 2.0 16V gls. and itstowards the driver and back, as if you were putting it in 6 gear.
- 12 June 2024, 06:27:59
- Welcome, Guest
News:
Search the maintenance guides for answers to 99.999% of Omega questions
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
77
Omega General Help / Re: Failed the MOT on steering idler,
« on: 09 March 2010, 10:29:43 »
I got mine from www.aoutovaux.com Never had any problems with it. and only paid £26 with delivery.
you could try them.
you could try them.
78
Omega General Help / Re: steering idler
« on: 06 March 2010, 15:13:36 »
More comenly known as "The ball joint from hell"
Lots of lube spray. if it wont come off then spray loads of rust eater / lube stuff (wd40) leave it over night and have a go in the morning. it should then come off very light.
Lots of lube spray. if it wont come off then spray loads of rust eater / lube stuff (wd40) leave it over night and have a go in the morning. it should then come off very light.
79
Omega General Help / Re: Rumbling noise
« on: 28 February 2010, 19:27:43 »
I would agree with mrjimbow, Sorry Debs.
its normal nothing to worry about.
its normal nothing to worry about.
80
Omega General Help / Re: engine problems
« on: 28 February 2010, 19:37:59 »
Might be a stupid question but are your plug wells are clean? ( no oil )
sounds more like a fuel or air problem, its not pulling air from somewhere is it? and is the pipe on your injectors fitted correctly. also check the fuel lines in the engine bay.
sounds more like a fuel or air problem, its not pulling air from somewhere is it? and is the pipe on your injectors fitted correctly. also check the fuel lines in the engine bay.
81
Omega General Help / Re: engine problems
« on: 25 February 2010, 16:50:46 »Quote
What exactly do you mean by
'all diagnostic tests and fuel tests' ?
Paperclip test.
http://www.omegaowners.com/forum/YaBB.pl?num=1189022687
82
Omega General Help / Re: 2000 omega 2.0 petrol interior fan wont get hot?
« on: 26 February 2010, 17:37:47 »
Have you checked the fueses and relays?
and have you bled the system?
and have you bled the system?
83
Omega General Help / Re: clip fault codes
« on: 21 February 2010, 19:12:30 »
Keep us informed of your progress.
Good Luck with the work mate
Good Luck with the work mate
84
Omega General Help / Re: clip fault codes
« on: 21 February 2010, 16:40:57 »
If you only got 1502 it is immobiliser no signal,
not to sure but I believe its normal as the engion is not running, no doubt others will correct me if I'm wrong.
I have attached a fault code list for you to see the other codes.
http://www.omegaowners.com/forum/YaBB.pl?num=1206569945
not to sure but I believe its normal as the engion is not running, no doubt others will correct me if I'm wrong.
I have attached a fault code list for you to see the other codes.
http://www.omegaowners.com/forum/YaBB.pl?num=1206569945
85
Omega General Help / Re: 12V socket.
« on: 20 February 2010, 15:31:16 »
It is easy enough to check your socket, open the car and before you put the key in the ignition plug in a sat nav or other thing to see if there is power.
86
Omega General Help / Re: help finding a boot seal
« on: 14 February 2010, 11:27:41 »
You could try a scrap yard or ebay. Or your best bet is in the parts section, ask one of the breakers, Dlk might have one.
87
Omega General Help / Re: Miss fire 3.0 MV6
« on: 06 February 2010, 16:05:53 »
I would tip more on the good old code 19,
I had the same prob with it and it was the cranc sensor
I had the same prob with it and it was the cranc sensor
88
Omega General Help / Re: omega 2l saloon petrol 2000
« on: 30 December 2009, 20:01:11 »
Have you cheked all fuses and regelars?
and also push off and auto together and turn the ignition on only till the lights are lit.
and also push off and auto together and turn the ignition on only till the lights are lit.
89
Omega General Help / Re: steering idler
« on: 28 November 2009, 12:45:39 »
It sounds like another Ball joint from hell.
I had a problem with mine, I used a bar, a bloody big hammer X2 and a joint remover, nothing worked, so I sprayed a lot of rust remover and wd40 and left it over night, the next day it just about fell off itself.
so spray a load on it and try tommorow.
I had a problem with mine, I used a bar, a bloody big hammer X2 and a joint remover, nothing worked, so I sprayed a lot of rust remover and wd40 and left it over night, the next day it just about fell off itself.
so spray a load on it and try tommorow.
90
Omega General Help / Re: power loss at 3500 rpm
« on: 23 November 2009, 12:18:03 »
Sounds like the same thing I had,
I bet you get code 19 crankshaft sensor.
I bet you get code 19 crankshaft sensor.