1
Omega General Help / Telltale voltage low fault 135
« on: 05 May 2011, 18:06:25 »
Does anyone know what fault 135 on a 2.5v6 petrol (telltale voltage low) actually means?
- 16 June 2024, 19:31:34
- Welcome, Guest
News:
Welcome to OOF
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Omega General Help / Re: Fault Code Check
« on: 04 May 2011, 19:51:09 »
Given it a good blast with Cataclean in. What I have noticed is the idle speed is now about at my long term 'normal' at 750 rpm whereas before to the blast recently it had been running around 1000rpm. I had spotted the 1000rpm was higher than usual but not really thought twice about it. Any thoughts on why idle rpm may have been running high previously?
3
Omega General Help / Re: Fault Code Check
« on: 04 May 2011, 17:55:39 »
Thanks. Have checked for exhaust leaks, given the advice, can't find any. Going to throw in a can of Cataclean, again given the advice, tonight and give it a run. Will take for re-test with fingers cross....everything seems fine apart from the mot 'fail'!
4
Omega General Help / Re: Fault Code Check
« on: 03 May 2011, 21:11:35 »
sounds promising. Do you know if no fault code means that my lambda sensors are ok?
5
Omega General Help / Re: Fault Code Check
« on: 03 May 2011, 19:56:38 »
Thanks. Just run the test. No codes showing other than 12 when engine on, with 12 and 31 while engine off.
on first 'short' mot test lambda was just over at 1.032 other readings ok. when did full test first fast idle was a fail on co but pass on lambda, while second fast idle was ok on co but fail on lambda....guy said "something screwed up here"
had new exhaust on recently. Secondary air mass not working i think makes noise on start up.
on first 'short' mot test lambda was just over at 1.032 other readings ok. when did full test first fast idle was a fail on co but pass on lambda, while second fast idle was ok on co but fail on lambda....guy said "something screwed up here"
had new exhaust on recently. Secondary air mass not working i think makes noise on start up.
6
Omega General Help / Fault Code Check
« on: 03 May 2011, 17:41:34 »
My 2.5 V6 failed mot on Lambda emissions. They are high. Garage said have engine code check done to see if this can help track down the fault.
Engine management light isn't on.
Is the code check worth doing if engine management light not on? Thanks
Engine management light isn't on.
Is the code check worth doing if engine management light not on? Thanks
Pages: [1]