Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - jamiro

Pages: [1]

Omega General Help / Re: Idler Arm

« on: 31 August 2011, 05:00:17 »

Quote

Hey chaps,

My passenger side Idler arm has gone, been to a few local shops and they all look baffled from what I ask for.

I have found one on eBay for £30ish but all shops want £120? The one I have found however is for 93-03, I have an 03 plate so not sure if it's a B or a C?

Could someone link me to one very cheap? I have an LPG converted CD Omega, as theres two sizes 110mm and 121mm i think they were?

Any help is appreciated.

Thanks in Advance
Colin!

Hey do you tried in racepages, I think I saw that part there, goodluck author!!!!

Omega General Help / Re: new custom stainless exhaust

« on: 31 August 2011, 04:14:28 »

Hi can you tell me how to remove the car mufflers? You mentioned here that you removed it, can you teach me how thanks

spam url link removed by admin

Omega General Help / Re: Errors P0130 and P0150 on Motronic 2.8.3

« on: 31 August 2011, 04:05:46 »

Quote

Hi

These are the errors I get.
P0550 - Power Steering Voltage High - Not Connected on my car-
(01) - Present
P0130 - O2 Sensor 1 Open Circuit
(04) - Not present
P0150 - O2 Sensor 2 Open Circuit
(04) - Not present

Now the whole story
Ok I switched to a Motronic M2.8.3 from a Vectra( Had a 2.8.1 from a Omega). When Cruising at higway speeds the EML comes on when you lift of the throttle ever so slightly,if you put your foot down the light goes out. I have some live data from the ECU and I can see that both O2 Sensors go from Closed loop to Open :confused: and the mv readings drop to 0. I know these errors can be caused by faulty sensors, but I never had a EML light on the 2.8.1 ECU . Does the Omega use different O2 sensors than the Vectra ?

I also had a problem with the elbow that runs form the intake to the brake booster, it broke when the pipe was removed so all I could do was to use some Q Bond with the filling powder. Now im thinking maybe I have a vacuum leak on that elbow thats causing the errors to show up, or a leak on the exhaust system. We checked the wiring but could not find any problems.