Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

General Car Chat / Re: Bonnet release broken !

« on: 13 April 2012, 00:17:38 »

I have newly acquired 'T' plate 2.5 TD Estate - and the plastic bonnet release by the driver's foot well has been broken off - I need to put some oil in and therefore need access to the engine bay - I believe I can tug the wire with some pliers (from what I have read) with a friend pressing down gently on the bonnet to assist in the releasing the bonnet catch - however, I cannot find out how to remove the black plastic panel in the right hand side of the driver's well to get to the wire (I am assuming that's where it is) - any guidance anyone please ?

Many thanks

come up to the midlands meet on the 29th. will sort it out for you.
see the midlands meet section. 

Thanks for the offer - if I can't resolve before then - count me in ! :-)

2

General Car Chat / Re: Bonnet release broken !

« on: 13 April 2012, 00:15:55 »

remove the black strip over the sill (one with Vauxhall logo on), revealing 4 torx screws. Remove 2 screws, and move front edge out of way, revealing another torx. Another torx near where handle should be. Plastic panel slides backwards, and out.

Many thanks indeedee !  Will check it out and report back - very much appreciated !  Thanks !

3

General Car Chat / Bonnet release broken !

« on: 12 April 2012, 18:33:40 »

I have newly acquired 'T' plate 2.5 TD Estate - and the plastic bonnet release by the driver's foot well has been broken off - I need to put some oil in and therefore need access to the engine bay - I believe I can tug the wire with some pliers (from what I have read) with a friend pressing down gently on the bonnet to assist in the releasing the bonnet catch - however, I cannot find out how to remove the black plastic panel in the right hand side of the driver's well to get to the wire (I am assuming that's where it is) - any guidance anyone please ?

Many thanks