Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Search the maintenance guides for answers to 99.999% of Omega questions

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - tutts

Pages: [1] 2
1
Omega General Help / Re: 2.5td vacuum pipes?
« on: 12 September 2010, 09:15:18 »
Well it looks like all of the vac pipes are ok,i removed the glove box yesterday to check the passenger side of the heater box and all seems ok,Then i had a think and wondered if there was a fuse for the hheater controls,looked in the book and it could be fuse no14 will have to investigate.

2
Omega General Help / Re: 2.5td vacuum pipes?
« on: 06 September 2010, 18:06:27 »
Well the pipe is still connected but i still do not seem to have vacuum at the heater(i remember hearing a sucking noise when changing from screen to floor etc before but not now) I think the flaps inside the heater box work off the vacuum so i must have a stuck flap, will have to investigate.

3
Omega General Help / Re: 2.5td vacuum pipes?
« on: 04 September 2010, 21:37:59 »
Finally managed to find the orofice that the pipe fits into.Must have pulled it when i changed fuel filter in june.What a stupid idea for a connector,Thanks again for the help i am getting pretty good at working on the engine now most things are tight to work on but have got the knack now. 8-)

4
Omega General Help / Re: 2.5td vacuum pipes?
« on: 01 September 2010, 08:18:59 »
Thanks think i should be ok now and will hopefully have a heater by the end of the day. I also cleaned out my bulkhead drain yesterday a job ive been putting off,glad i did it now it was well blocked (no more water into heater from pollen filter) Thanks in advance again Chris.

5
Omega General Help / Re: 2.5td vacuum pipes?
« on: 31 August 2010, 21:53:57 »
Cheers i will have a look tomorrow its a good job im on holiday this week and dont need my car. :y

6
Omega General Help / Re: 2.5td vacuum pipes?
« on: 31 August 2010, 21:47:37 »
Its the hbv one with the elbow on near the aircon valve.Does it go through the bulkhead too near the matrix pipes,i cannot seem to find a hole :'(

7
Omega General Help / Re: 2.5td vacuum pipes?
« on: 31 August 2010, 21:33:50 »
Everything else seems ok(pipes onto top of pollen filter/pipes onto one way valve/ pipe onto matrix take off. Its just the one from the hbv the pipe is only about 300mm long so it must go somewhere near matrix pipes?

8
Omega General Help / Re: 2.5td vacuum pipes?
« on: 31 August 2010, 21:28:00 »
Photobucket album    http://s920.photobucket.com/albums/ad50/chris230163/car/ sorry.Chris.

9
Omega General Help / Re: 2.5td vacuum pipes?
« on: 31 August 2010, 20:08:56 »
Have removed wipers scuttle and wiper linkage,still cannot find where this pipe goes.one vac pipe is connected to the left of the top matrix pipe ,it goes to ns into scuttle (heater box near pollen filter) There is also a vac pipe from one way valve on main vac pipe from vac pump,This also goes to heater box near pollen filter.Also on one way valve is a pipe that goes to egr valve and sensor near battery and that is it.i have taken a photo of matrix pipes and one way valve.http://i920.photobucket.com/albums/ad50/chris230163/car/SDC11007.jpghttp://i920.photobucket.com/albums/ad50/chris230163/car/SDC11003.jpghttp://i920.photobucket.com/albums/ad50/chris230163/car/SDC11004.jpghttp://i920.photobucket.com/albums/ad50/chris230163/car/SDC11005.jpg

10
Omega General Help / Re: 2.5td vacuum pipes?
« on: 28 August 2010, 17:54:47 »
Thanks will have a look if not will take some piccies and post them cheers.

11
Omega General Help / Re: 2.5td vacuum pipes?
« on: 28 August 2010, 17:50:18 »
I thought it was the hbv but was not sure it only has two water pipes connected and one vac pipe yes with an elbow and a length of black vac pipe. ta

12
Omega General Help / Re: 2.5td vacuum pipes?
« on: 28 August 2010, 17:34:50 »
Hi yes it has aircon the heater matrix pipes come forward from the bulkhead on the o/s,there is around valve in the middle of one of the pipes with a vacuum take off,the vac pipe goes towards the bulkhead but mine is not connected to anything

13
Omega General Help / 2.5td vacuum pipes?
« on: 28 August 2010, 10:02:05 »
Hi does anyone know where the small vac pipe from the heater valve on the o/s of the engine (near the headder tank )go to mine has pulled out and resulted in no vacuum to the heater at all no control at all. Thanks Chris.

14
Omega General Help / Re: No Demist! Servo?
« on: 07 September 2010, 07:47:09 »
I am having the same problems i found a loose vacuum pipe under the bonnet near the heater matrix pipes on the bulkhead bu still not working,i will be looking for the heater box flap actuator at weekend i will keep you posted.Take a look at my other post on vac pipes. :-[

15
Omega General Help / Re: FIRRRE!!
« on: 01 September 2010, 08:23:55 »
Short journeys wont help filler tube gunk,Engine does not get hot causing condensation causing oil to emulsify,change oil flush and change oil again and give it a decent run.good luck on the fire.

Pages: [1] 2

Page created in 0.01 seconds with 13 queries.