Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - BobCoombs

Pages: [1]
1
Omega General Help / Re: 2.2dti diesel primer
« on: 26 March 2013, 14:47:06 »
Right, just bought one off fleabay, I'll connect to the inlet side of the filter so it draws from the tank & pumps through the filter to the injector pump & let's see if she goes :)

2
Omega General Help / Re: 2.2dti diesel primer
« on: 26 March 2013, 12:48:26 »
So just to clarify, fit the primer pump between the tank & the inlet to the diesel filter or to the outlet of the diesel filter?

3
Omega General Help / Re: 2.2dti diesel primer
« on: 26 March 2013, 10:09:47 »
Hi, many thanks, this is my first 2.2, I had the 2.5s before this. So you put yours in the pipe that runs from the filter to the pump? My filter is full of diesel but I'm getting almost nothing at the injectors so I've been reading up on here & it seems to be a VERY common problem which most cure with one of the squeezy bulb type primers. I was looking on eBay & they're only a fiver so thought it would be worth a go before I destroy ( if I haven't already) my starter motor

4
Omega General Help / 2.2dti diesel primer
« on: 26 March 2013, 09:38:06 »
Hi fellas, new to the site but with a common problem I think. Changed the fuel filter in my 2.2dti & it won't start, have cranked it for hours with no joy to the point where I may have damaged the starter motor. Many of you seem to have fitted the squeezy bulb type primer to the 'out' line on the filter but can I ask what size pump you used as the seem to come in 6,8,10 & 12mm sizes? Did you just cut the plastic fuel line & secure with jubilee clips?
Many thanks for your help. Bob

Pages: [1]

Page created in 0.008 seconds with 14 queries.