Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Search the maintenance guides for answers to 99.999% of Omega questions

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - glyno

Pages: [1]
1
...after 2 miles.

I had problems with the sensors last year..all replaced (3 I think?) and all ok until last week.  The EML came up and it was the Camshaft sensor again.  Had it replaced, but came up straight away....took it straight back to the garage where they say it must be a 'deeper' electrical problem.  Has anyone had a similar problem...a friend mentioned that it could be that the sensor wasn't fitted properly??  P.S. I know nothing about cars, so if anyone has a layman's explanation.
Omega Estate 2L 16V 1999T (170K)

2
Omega General Help / Re: Screen washer jets
« on: 23 September 2007, 16:27:05 »
Hi,

It is the actual jets embedded in the bonnet.  One had stopped working so I opened up and saw the rubber hose hanging.  The bit of plastic that the hose goes on had broken.  In checking this out,  the other one also decided to break off.   I live in a hard water area and have seen this sort of thing before.  Basically, I've got to get the old jet out and reattach the hose, however it didn't look totally straight forward.


3
Omega General Help / Screen washer jets
« on: 23 September 2007, 16:14:51 »
Hi,  

My screen washer jets have stopped working, due to fatigue.  The actual pump is fine.  

Is it an easy job to replace these (totally useless as car maintenance) or would it be a cheap job to have done by a garage?

Any guidance would be much appreciated.

Omega estate 2.0 16V 1999.

Pages: [1]

Page created in 0.011 seconds with 15 queries.