Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Search the maintenance guides for answers to 99.999% of Omega questions

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - JeffBarre

Pages: [1]
1
I do appreciate your help. I fitted the hand primer to make sure the fuel system was bled through properly. It is fitted between filter and pump. The fuel passes through nicely. The rev counter and speedo work fine. Im not a great believer in coincidence and the car ran perfectly before the crank pulley went. Any other ideas gratefully received.

2
Not long had fuel filter by garage who did pulley. I have stripped it and made sure they did it right !! I thought crank sensor but Im told if thats gone the rev counter wont work but mine does.

3
Stripped and checked every vacuum pipe and they are all perfect. This all started after the crank pulley went and a new one was fitted. I think the garage ran it out of fuel. Have bled system and put a primer  in the fuel line. I thought I had found it at first with a broken vac tube but when I repaired it no improvement. I cant see any damage caused by the fan belt the only think in its path is the Maf but I cant see that causing this fault

4
Omega General Help / 2.2 dti wont rev lumpy tickover hard starting
« on: 08 January 2014, 18:48:17 »
My 2002 2.2 dti is very hard to start, when it runs the tickover is lumpy but does improve after a while. Wont rev past about 1200. The management light comes on but code reader says no codes. When its warm if you turn it off and restart it will rev a couple of times and then its back to no revs. Egr is clean, vac pipes checked only thing left is to pour petrol over and light a match . HELP !!

Pages: [1]

Page created in 0.008 seconds with 14 queries.