Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega General Help / Re: V6/2.2 dti clutch height

« on: 23 July 2015, 13:44:38 »

Actually they were trying to sell me something that if they had read the thread they would know I didnt want but apologies if any offense caused.

Do you think I might get some answers on somewhere like migweb? I thought this forum would be ideal. I actually used to have a carlton gsi and an omega a while back.

2

Omega General Help / Re: V6/2.2 dti clutch height

« on: 23 July 2015, 10:23:02 »

I don't want your spacer I want to make my own. It will be different to your spacer please read my post properly.

3

Omega General Help / Re: V6/2.2 dti clutch height

« on: 22 July 2015, 13:37:44 »

Yup that spacer is too big retro power make it I think. The corsa clutch is almost in the correct position but not quite. So I need to make my own spacer so I need that measurement.

4

Omega General Help / Re: X25XE transplant

« on: 22 July 2015, 08:57:00 »

I didn't know you got them over there either! I guess its an opel not a Vauxhall?

You might be able to help me with my question if you have your engine out of the car still.?
http://www.omegaowners.com/forum/index.php?topic=131664.0

5

Omega General Help / V6/2.2 dti clutch height

« on: 22 July 2015, 08:54:27 »

Hi all

Could find any info on this anywhere on the net. I am using an R28 gearbox in a rwd engine swap conversion using a corsa vxr engine. I had a clutch drive plate made but need to get the slave cylinder in the correct position. I need to know the clutch cover fingers height/distance from the block face where the gearbox bolts up to?? It could probably be from any engine using the concentric slave cylinder as they all the same I think.

Appreciate any help.