Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega General Help / crank sensor testing

« on: 21 March 2007, 14:14:32 »

Is there a way of testing before installing?  

2

Omega General Help / Re: My Meggy wont start

« on: 13 March 2007, 21:22:43 »

The Boy; Thanks mate i intend to do that   , but i'll bet they're a bugger to fit at the top end  :exclamation
Will also check if there is a 19 fault code RPont, Thanks mate  

3

Omega General Help / Re: My Meggy wont start

« on: 13 March 2007, 11:08:01 »

Good morning gents. I've done the paper clip test and it read * - ** = 12, and *** -* = 31 fiddled with the wires and hey presto! she's running. I will however get a fresh sensor in case it happens again. Thanks for all your help and suggestions, very appreciated  
                                                                                                    Mick  

4

Omega General Help / Re: My Meggy wont start

« on: 12 March 2007, 10:43:00 »

Thanks guys, getting her up in the air today to get a better look. There is another sensor hanging down at the side of the oil filter! dunno why?,it's not in use tho. It's been like that since last August.  I aint got a tester for the codes, but i'll see what i can do when i get under her. She's a 2.5 v6 1998 cd and was running beautifully till now. If i dont have any joy i'll try and get a tester for the codes. Will get back to you on progress, Thanks again guys your help is much appreciated.
                                                     Mick

5

Omega General Help / My Meggy wont start

« on: 11 March 2007, 12:34:11 »

Parked her up in the garage yesterday tried to start her today. She winds over ok, all the dash lights come on but the eml and battery light stay on. Can anyone please help me  
cry

6

Omega General Help / Re: dont know if you know?

« on: 04 February 2007, 22:02:01 »

Well done, very handy site  

7

Omega General Help / Re: Side Light Out

« on: 23 December 2006, 20:56:24 »

Did what Chopsdad suggested and yes Andy they  are all glass wedge fit into bulb holder.   As was said, a bit difficult to get out. I've replaced the bulb with a 5watt, same as the one I took out. Working fine now, so you were both right with your info, thanks again for your help, especially Chopsdad.
                                             Mick

8

Omega General Help / Re: Side Light Out

« on: 22 December 2006, 22:42:54 »

Good Idea, I'll do that.  

9

Omega General Help / Re: Side Light Out

« on: 22 December 2006, 22:12:41 »

Thanks Chopsdad, I'll get it done tomorrow now that I know that, cheers mate.
                                                                                                     Mick http://www.omegaowners.com/forum/Templates/Forum/default/thumbsup.gif
Thumbs Up!

10

Omega General Help / Side Light Out

« on: 22 December 2006, 21:54:33 »

I've got a nearside sidelight out, can anyone tell me if the bulb holder just pushes in or held in by a clip?. Would appreciate any help.
Mick  

11

Omega General Help / Re: Knock Sensor &  cranckshaft Sensor

« on: 06 November 2006, 22:09:50 »

Thanks for your info guys really appreciated. I've just read "Marks DTM calib"article about the Knock Sensor on the Tech Info page which I should have done earlier, I'm learning loads! . I'm gonna have another look under there tmorrer.   If that's right what "The Boy" suggest's I'll leave well alone ( :question) Thanks again .

12

Omega General Help / Knock Senser &  cranckshaft Senser

« on: 06 November 2006, 20:02:26 »

 When I did an oil and filter change today I noticed a knock senser hanging by the side of  the filter. I've only had my meega a few weeks and it runs like a dream. Do I leave well alone or did I ought to fit it to the block as it should be. D'ont want to spoil performance. V6 2.5 :-/  

13

Newbie Welcome Area / Re: New Member

« on: 03 October 2006, 22:49:07 »

Hi mate, you've certainly come to the best forum. Good bunch on here. I had a  beemer but I like my Meggy better.  

14

Newbie Welcome Area / Hello...

« on: 04 September 2006, 20:03:21 »

I've just changed to an Omega v6 after owning a BMW 5 series for 4 years. Great car up to now, with lots more equipment and beautiful to drive. You all seem to be a good bunch and I look forward to using the forum. I'm getting on a bit  though just turned 64yrs young.