Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Search the maintenance guides for answers to 99.999% of Omega questions

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - jasonxr2racer

Pages: [1] 2
1
Omega General Help / Re: Turns over but won't fire? HELP!!
« on: 28 May 2008, 13:53:45 »
Sounds like same prob as i'm having but i got a code 74.

Try removing pipes leading to inlet plenum and see if it starts.

Mine does doing that.

Going to try another MAF sensor when it arrives.

2
Omega General Help / Re: Intermittant drop in idle RPM
« on: 28 May 2008, 13:56:02 »
Could be a vac leak?

3
Checked everything today.

4
Quote
Blocked or too dirty air filter?

Faulty air flow meter?

Well when i did clip test faults came up on TPS high voltage and  Mass Air flow sensor High voltage.

Could it be that then?

Before these probs the idle when warm was irratic going from 1000rpm up to 1600 RPM and back constantly.


5
Had another try to get Omega going today.

Checked all the Vac pipes and all ok.

I could only get the car to run when I removed the Ram pipes from the Inlet manifold.

Also would only idle if pipe from ICV was removed from ram pipe.

Any ideas?

6
Cant do that task cos i cant get it to run.

Now off the road and Vectra back in use.

Car will be sold once sorted!!!!

7
I suspected the TPS to be suspect with my first problem of the idle going up and down from 1000 to 1500 RPM when car was warmed up.


8
Thats been said before but checked pipes.


9
Omega General Help / Re: Major probs! Help please!!!!
« on: 19 May 2008, 20:25:03 »
Did clip test and these 2 faults came up obviuosly with engine not running.

code 21 Throttle pos Sensor (High voltage)

code 74 Mass Air Flow Sensor (High voltage)

Any ideas?

10
Omega General Help / Re: Major probs! Help please!!!!
« on: 19 May 2008, 13:57:37 »
Will do clip test tonight!!!!

11
Omega General Help / Re: Major probs! Help please!!!!
« on: 18 May 2008, 20:44:25 »
ECU light is on.

12
Omega General Help / Re: Major probs! Help please!!!!
« on: 18 May 2008, 20:03:26 »
Cheers I thought it could be.

13
Right not used the omega for 3 days as it is P*****g me off.

Started up today, was very lumpy and runnig rough cold.

Was also popping back through the air box and inlet pipes.

Set off after 3 mins, got as far as half a mile and it cut out.

Stuck just turning left at set of lights looked a right K**b

Tried starting wouldn't have it and stank very eggy.

I though it may be the cats but it wouldn't start at all if completely blocked?

Could it be Lambda sensors?

I'm considering getting rid cos i don't need this hassle when going racing next weekend.

Think the diesel Vectra is going back on the road!!!!

14
Omega General Help / Re: Power Steering Pump 2.5 V6 1999
« on: 17 May 2008, 20:16:16 »
Quote
To get by, spray WD40 at pump shaft seal, through the holes in the pulley or from the back of the pump.

regards
richard a

Yeah did that and it starts agian not long after.

Just want to know if It will be ok to drive and not fall apart cos I'm going to Anglesey next friday night as I'm racing there.

15
Omega General Help / Re: Power Steering Pump 2.5 V6 1999
« on: 16 May 2008, 15:08:45 »
It is quite noisy but only just started.

When i rang parts place they needed a number off the pump to match it up.

Said there are about 4 different ones?

Pages: [1] 2

Page created in 0.012 seconds with 13 queries.