Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega General Help / Re: multi function display

« on: 29 August 2008, 09:21:03 »

Hi pete elite and chris gixer...thanks for the information....to repair they where asking a lot of money...but managed to get one off ebay from your recommendation....did try another guy off ebay...he was advertising a unit at a fixed price ,spoke to him and said he would double check, he phoned me back said it was now rare and was going to auction it instead.....somewhere near heathrow is his advert....not cricket that old boy...so beware oif you come accross him.
thanks again chaps much appreciated.

2

Omega General Help / multi function display

« on: 28 August 2008, 19:54:02 »

Hi, Apart from my previous posts i now have a new problem, i seem to have lost part of the pixels from my multi function display. is it possible to buy a refurbished unit? if so where from? thank you

3

Omega General Help / Re: heater proplems omega v6

« on: 26 August 2008, 18:38:31 »

Thats brilliant mate will give it a all a good clean and get back to you in a couple of days. cheers very much mate.

4

Omega General Help / Re: heater proplems omega v6

« on: 26 August 2008, 17:04:39 »

Hi, I think i must be at the wrong bit...are we talking about the plastic section on the top of the engine? at the bulk head end is the breather pipes, in the midle its connected to the top block by an hex bolt, at the opposite end theres 2 very short plastic pipes that then go into the front block section....when i saw a pic of these they look to be like a bayonet type fitting to stop them pulling out. the section i read on here, the guy says to clean out the breather box with thin wire?

5

Omega General Help / Re: heater proplems omega v6

« on: 26 August 2008, 16:12:55 »

Hi ians, sorry mate ,   yes i think its the throtle body, opposite end to the cluster of breather pipes...they look to be 2 short plastic pipes and a type of bayonet fitting shape on the photos, didn't want to prise them to hard.

Pulled the plug leads ....no oil sitting there.

thanks for your help mate its driving me potty

6

Omega General Help / Re: heater proplems omega v6

« on: 26 August 2008, 09:23:15 »

Hi thankyou for the help Ians and low- knee.
 Did try reseting the flaps for direction all working well and plenty of air, its just cold at pass side. don't know if this will help but came home from work last winter and the heater blower stayed on, couldnt turn it off. Took out the ignition key etc, got up next morn and it had stopped, but it seems after that the problems started.

It sometimes seems the waters not flowing all the way around the engine and then it gets a bit hot and blows the oil?

Did try to clean the breather system but couldn't remove it from the front of the engine, will have another go...thanks

7

Omega General Help / heater proplems omega v6

« on: 25 August 2008, 10:50:44 »

  hi thankyou for the welcome. i  have a omega v6 with a frustrating problem.i cant get any hot air onto passenger side windscreen. the controls work ok the fan works ok, have flushed the matrix and engine, have checked connectors and pipes.....i do have some emulsion in filler cap...temp goes just over the 90 mark....when i stop i get a slight smell of oil and a bit of smoke from near header tank pipes. if anybody can help...thank you.