Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega Electrical and Audio Help / Re: Alarm Query

« on: 05 February 2009, 00:42:44 »

In case I have problems sourcing replacement batteries and decide to disconnect PS, will this stop the main alarm from operating or just the alarm when someone attempts to disconnect the battery to stop the main alarm?
I guess what I need to know is the impact of disconnecting the PS permanently and how that affects the general alarm
Bazza

2

Omega Electrical and Audio Help / Re: Alarm Query

« on: 05 February 2009, 00:08:32 »

Thanks everyone for the reply, I'll get it checked out.
Bazza

3

Omega Electrical and Audio Help / Alarm Query

« on: 30 January 2009, 00:19:28 »

Hi all,
Apologies if this has already been covered, but I have been searching through and have been unable to find anything related.
The issue I have on my facelift (02) CD Miggy 2.6 is that on occassion when I switch off the ignition, I sometimes get three audible beeps that see to be coming from the alarm.
I thought at first that I was accidently pressing one of the buttons on the key fob as I withdrew it from the ignition, however I have checked and this isn't the case.
Does anyone have any idea what the cause of this may be? Is it an early warning perhaps of something going wrong electrically?
Many thanks for any assitance

4

Omega General Help / Re: Mayo has me all confused

« on: 23 March 2009, 00:26:53 »

Thanks again for the info. Will certainly keep an eye on this and make sure that I keep the mayo on the chicken sandwich  

5

Omega General Help / Re: Mayo has me all confused

« on: 22 March 2009, 17:57:57 »

Sounds better than an possible HG going, thanks for the info.

Bazza

6

Omega General Help / Mayo has me all confused

« on: 22 March 2009, 17:53:28 »

Hi all,
Got a message on my 02 2.6 mig yesterday stating check oil. So checked oil and was down about half way on dipstick when cold. So thought I would add a little oil, shock horror when I took Oil filler cap off there was loads of mayo in the filler tub and on cap!!
I have checked condition of oil and all ok and water is clear too, the car has not overheated once since I got it in January and there has been no loss in fluids (unlike my last Rover 75!!).
Is there any possibility of water getting into filler tube, enough to generate mayo. The car was completely clear of mayo 3 months ago.
Any suggestions welcome.
Bazza

7

Newbie Welcome Area / Re: Oldie but newbie

« on: 01 January 2009, 17:53:37 »

Thanks for the warm welcome chaps!!

8

Newbie Welcome Area / Oldie but newbie

« on: 01 January 2009, 17:37:16 »

Hi all, I am a newbie to this forum, previously had a 2.5 v6 miggy on an N plate, was a bit of a rogue so chopped it for a rover 75. Pleased to say I am waiting to take delivery (as soon as the money clears) of an 02 2.6 v6 CD as i have yet to find a car that drives so well (even if my last one was a rogue.
Look forward to communicating with you all.
Barry