1
Omega General Help / Re: Help
« on: 01 August 2010, 14:39:01 »
SAI valve ?? location 
- 27 October 2025, 15:54:38
- Welcome, Guest
News:
Welcome to OOF
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Omega General Help / Re: Help
« on: 01 August 2010, 14:36:16 »
All plugs in the right position,throttle housing cleaned.
water problem now solved i think air lock
water problem now solved i think
air lock
3
Omega General Help / Help
« on: 01 August 2010, 12:44:55 »
Hi all please help getting codes from paper clip test of
0100
0110
engine reving high and surging,
just done head gasket, cleaned all breathers ect, and car getting hot ie fan kicking in every 5 mins just took off expantion cap no pressure but coolant overflowed after a minuite or so just letting it cool down now, maybe just an air lock
any ideas lads
0100
0110
engine reving high and surging,
just done head gasket, cleaned all breathers ect, and car getting hot ie fan kicking in every 5 mins just took off expantion cap no pressure but coolant overflowed after a minuite or so just letting it cool down now, maybe just an air lock
any ideas lads
4
Omega General Help / Head Gasket
« on: 24 July 2010, 10:48:26 »
Hi What head gasket set would you recomend for a 2.0L XEV and where to buy
Thanx
Thanx
5
Omega General Help / Poor start up
« on: 14 July 2010, 12:54:24 »
Hi all, Please help over the last 4 weeks the mig seems to be getting worse,from cold start up its like its only firing on three pistons,and it sounds very hollow through the air filter box then all of a sudden after about 30 secs the hollow noise stops then its back to running normal, and also noticed the last 4 weeks that the tick over has become very low it normally ticks over at about 900 rpm but it has dropped to about 700 rpm any ideas please, thanks
Tim
p.s no codes on paper clip test
over the last 4 weeks the mig seems to be getting worse,from cold start up its like its only firing on three pistons,and it sounds very hollow through the air filter box then all of a sudden after about 30 secs the hollow noise stops then its back to running normal, and also noticed the last 4 weeks that the tick over has become very low it normally ticks over at about 900 rpm but it has dropped to about 700 rpm any ideas please, thanks Tim
p.s no codes on paper clip test
6
Omega General Help / Re: Failed Mot emissions
« on: 11 February 2010, 07:42:58 »
Hi, Yes i did everything you guys sugested changed spark plugs, cleaned out the breathers, i even put in some wyns pre Mot emissions cleaner,when i took it back for mot it failed again at about the same readings as before which led me to believe it was either the cat or the lambda, thanks to you all for helping me out, the car is running much better now 
Tim
Tim
7
Omega General Help / Re: Failed Mot emissions
« on: 10 February 2010, 21:56:10 »
Hi guys just to let you know car needed a new cat,now got 12 months MOT
8
Omega General Help / Re: Failed Mot emissions
« on: 06 February 2010, 21:56:58 »
Thanks alot guys will get on it in the morning ive got ten days for a free re test,i think im going to change the plugs and clean out the breathers not done them for a while.
do i give it the (italian tune up) just before i take it back for re test ?
Thanks again
Tim
do i give it the (italian tune up) just before i take it back for re test ?
Thanks again
Tim
9
Omega General Help / Failed Mot emissions
« on: 06 February 2010, 21:12:34 »
Hi all
The car failed MOT today on emmissions a little help needed
2.0 ltr 80.000 miles
runs great no problems at all,no eml light. no fault codes either
test result as follows
fast idle test engine speed =2880 rpm pass
co =0.57 %vol fail 0.30
hc =131 pass 200
lambda = 1.022 pass min 0.970 max 1.030
second fast idle
engine speed =3210 pass
co =0.50 %vol fail max 0.30
hc =121 pass 200
any ideas what to look for
Thanks all
The car failed MOT today on emmissions a little help needed
2.0 ltr 80.000 miles
runs great no problems at all,no eml light. no fault codes either
test result as follows
fast idle test engine speed =2880 rpm pass
co =0.57 %vol fail 0.30
hc =131 pass 200
lambda = 1.022 pass min 0.970 max 1.030
second fast idle
engine speed =3210 pass
co =0.50 %vol fail max 0.30
hc =121 pass 200
any ideas what to look for
Thanks all
10
Omega General Help / Re: Vibration ??
« on: 02 September 2009, 18:01:43 »
Hi all, my mig did the exact same thing as yours, I have just changed my wishbones and drop links and it has solved the problem,now it runs level and a lot smoother
Tim
Tim
11
Omega General Help / Pressure switch
« on: 06 August 2009, 15:29:23 »
Hi Just had the ultra violet check on the aircon and its leaking around the pressure switch,now lost all the gas, is it an easy job to replace this switch??
Tim
Tim
12
Newbie Welcome Area / Newbie saying hello
« on: 29 July 2009, 14:05:57 »
Hi everyone [smiley=happy.gif] new to the forum,just saying hello to you all [smiley=thumbsup.gif] great site this, very informative, ive got some great tips from this site, ive been lurkin for a while just reading a lot of posts.
i drive a Omega 2.0 GLS w reg, had it for a while now but just recently had a few probs with the dreaded exhaust manifold studs [smiley=sad.gif] and had to take off the head and have it skimmed studs drilled ect ect, but its up and running great now 8-) Cheers [smiley=beer.gif]
Tim
i drive a Omega 2.0 GLS w reg, had it for a while now but just recently had a few probs with the dreaded exhaust manifold studs [smiley=sad.gif] and had to take off the head and have it skimmed studs drilled ect ect, but its up and running great now 8-) Cheers [smiley=beer.gif]
Tim
Pages: [1]