1
Omega General Help / Re: Exhaust System
« on: 01 October 2010, 20:53:31 »
I know where there is a 2.5 being broke in a yard in cannock if a second hand one any good
- 09 May 2025, 02:48:58
- Welcome, Guest
News:
Please check the Forum Guidelines at the top of the Newbie section
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1] 2
2
Omega General Help / Re: high temperature problem
« on: 29 October 2010, 16:07:40 »
water looks fine, no signs of any oil or anything, doesnt seem to be any water flow but will check water pump tomorrow. thanks
3
Omega General Help / high temperature problem
« on: 29 October 2010, 06:39:10 »
Hi on my way home from work this morning the temperature suddenly when right up and the warning light came on as I was on a dual carageway with no where to stop put in neutral and started to coast the temp then dropped and light went off so up in drive again and sure enough the temp started to rise again. ?? so did this to get me home
Checked water and oil when it had cooled down and found nothing wrong. Any ideas ??
Checked water and oil when it had cooled down and found nothing wrong. Any ideas ??
4
Omega General Help / Re: Front Sub Frame
« on: 31 August 2010, 11:39:41 »
Hi try using some metal filler as temp repair untill you can get it done 
5
Omega General Help / Re: Welding on car
« on: 30 August 2010, 14:23:22 »
Always disconnect negative side of the battery as it just depends on where the alternator rotor has stopped you may be unlucky and it will damage the rectifyer if in the wrong place.
6
Omega General Help / Re: automatic gearbox replacement
« on: 27 August 2010, 21:46:20 »
watch out when removing and fitting the electrical conecting plugs as you can easily bend the conectors or push the socket into the gearbox (especially if the plastic on the socket as gone fragile)
7
Omega General Help / Re: help required id of washer found in the sump
« on: 27 August 2010, 20:09:29 »
don't need a facebook account to view that link. tis a public link silly me didnt try bending it though and have now discovered is a cam cover seal... duh!!!!
silly me didnt try bending it though and have now discovered is a cam cover seal... duh!!!!
8
Omega General Help / Re: help required id of washer found in the sump
« on: 27 August 2010, 20:02:46 »
link now sorted... i think!!!
9
Omega General Help / help required id of washer found in the sump
« on: 27 August 2010, 19:59:01 »
hi all just removed sump on my v6 to clean pick up pipe as i have had oil light comin on when warm and found a washer with four indentation on the edges in the sump anyone got any ideas what it could have come off http://www.facebook.com/album.php?aid=202355&id=757234280&l=38d376b37a
10
Omega General Help / Re: 2.5 / 2.6 head gasket difference???????
« on: 16 August 2010, 14:22:26 »
Third omega v6 I have had each one at some point I have needed to change the head gaskets may be running on lpg causing the problems or just the mileage I do each car has been over 150 thou. (always at the speed limit 
)
)
11
Omega General Help / Re: 2.5 / 2.6 head gasket difference???????
« on: 16 August 2010, 13:10:31 »
going to try and see if they fit as being multi layered steel they will act like the uprated ones you can get for k series rover engines .As driving hard for 70 miles a day means head gaskets only seam to last 12 months (running on gas as well.) 
12
Omega General Help / Re: 2.5 / 2.6 head gasket difference???????
« on: 15 August 2010, 23:45:14 »
Been given 2.6 head gaskets for nothing but have not started to strip heads off my car yet so was just checking if anyone knew before I started.
13
Omega General Help / Re: 2.5 / 2.6 head gasket difference???????
« on: 15 August 2010, 23:30:31 »
Will the 2.6 gasket fit a 2.5 ??
14
Omega General Help / 2.5 / 2.6 head gasket difference???????
« on: 15 August 2010, 22:52:10 »
Hi can anyone tell me if there is any difference between a 2.5 and a 2.6 cylinder head gasket ?
Also my 2000 2.5 omega as started used lots of oil (no leaks) but oil light started to come on went warm on tick over but goes out if revs increased slightly any ideas ?
Also my 2000 2.5 omega as started used lots of oil (no leaks) but oil light started to come on went warm on tick over but goes out if revs increased slightly any ideas ?
15
Omega General Help / Re: speedo not working
« on: 03 October 2009, 23:08:53 »
Second hand radio out of the car in the yard no paper work with the car, therefore no hope of the car pass 
Pages: [1] 2