1
Omega General Help / Re: car still not starting
« on: 05 April 2010, 14:46:28 »
ok lads just done paper clip test .......... results are code 19 whits wrong with it boys
- 14 July 2025, 11:28:20
- Welcome, Guest
News:
Welcome to OOF
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1] 2
2
Omega General Help / Re: car still not starting
« on: 05 April 2010, 13:43:01 »
have already checked out other crank sensor it has different fittment plug will try and do paper clip test today
3
Omega General Help / Re: car still not starting
« on: 04 April 2010, 18:15:08 »
ok guys happy easter to all . so i didnt do paper clip test instead had my mate stick his diagnostic machine on car all it says is wrong rpm signal this was verified with my brohters mate who has just bought a new snap on machine and it came up wiht the exacy same message. also bouhgt new camshaft sensor to no avail think next step is the scrappies.
4
Omega General Help / Re: car still not starting
« on: 29 March 2010, 18:53:48 »
CHANGING THE CRANK SENSOR ON MINE TAKES LITERALLY 5 MINS. how do i do paper clip test and would i do it with new sensor in or my 8valve one 
?
?
5
Omega General Help / Re: car still not starting
« on: 29 March 2010, 17:46:42 »
just been to my local vx dealer explained the situation . cant believe they cant help ,nothin else they can do for me .so where do i go from here HELP PLEASE.
6
Omega General Help / Re: car still not starting
« on: 28 March 2010, 18:48:44 »
no sorry dont remember codes but it did list AFM which i replaced with brand new one and have also replaced new coil pack.
7
Omega General Help / Re: car still not starting
« on: 28 March 2010, 18:17:23 »
yes my mate came over with his machine and it said crank sensor faulty hence new purchase from vauxhall. guy at counter says that 90458251 is only one he does for my car but it dont work.
8
Omega General Help / Re: car still not starting
« on: 28 March 2010, 17:47:53 »
Yes its 2ltr 16valve ecotech
9
Omega General Help / car still not starting
« on: 28 March 2010, 17:43:05 »
hi guys back again after some abscence still have problem with my motor. NEW crankshaft sensor from vauxhall PART NO. [90458251] will not start car .Today i took sensor from my old sri 8valve and it started although runs very badly so can someone tell me why vauvhall replacement isnt even allowing my car to spark please help guys.
10
Omega General Help / Re: my motor wont start
« on: 16 January 2010, 22:01:51 »
its the exact same crank sensor that i purchased from my local VX dealer
11
Omega General Help / Re: my motor wont start
« on: 16 January 2010, 20:53:47 »
I am in AYR Scotland
12
Omega General Help / Re: my motor wont start
« on: 16 January 2010, 19:32:05 »
lads im at my wits end . New maf, Another newCrank Sensor,New Camshaft Sensor and Brand New Coil Pack and low and behold its still not starting and still no spark. My Mate put daignostic on car and it has no code faults. Where do i go from here. On a Happier note my lad just bought a "T" reg 2ltr with 57000 from new for £400 JAMMY SOD.
13
Omega General Help / Re: my motor wont start
« on: 14 January 2010, 19:12:43 »
Is that why i dont get spark and if so has vx sold me the wrong sensor although they only list 1 for my car
14
Omega General Help / Re: my motor wont start
« on: 14 January 2010, 18:02:49 »
Tried That too. The wierd thing is if i put on an old crank sensor it bangs and clanks all over the place when trying to start it as if timing is miles out BUT it eventually starts although its rough and under powered . The NEW crank sensor allows it to turn over smoothly but will not start.
15
Omega General Help / Re: my motor wont start
« on: 14 January 2010, 17:42:08 »
MAF was brand new from local motor factor and Crank sensor new from vauxhall dealer
Pages: [1] 2