1
Omega Electrical and Audio Help / Re: Pre Face Lift - Climate Contol - Temp Backlight
« on: 10 April 2010, 19:41:17 »
That's brilliant mate, thanks a lot. (Did try searching but couldn't find [smiley=sad.gif])
- 05 February 2026, 01:03:40
- Welcome, Guest
News:
Please play nicely. No one wants to listen/read a keyboard warriors rants....
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Omega Electrical and Audio Help / Pre Face Lift - Climate Contol - Temp Backlight
« on: 10 April 2010, 18:33:01 »
Re: my MV6, it has the pre face lift Electronic Climate Control. (The 4 circular controls). The passenger side temperature control backlight doesn't light (you can just make out the figures in the daylight).
Is it possible (once the whole panel is out) to remove this individual switch and replace / solder in, a new bulb? If so, what type is it?
Is it possible (once the whole panel is out) to remove this individual switch and replace / solder in, a new bulb? If so, what type is it?
3
Omega General Help / Re: Temperature Gauge not working
« on: 17 April 2010, 21:21:22 »
OK thanks, I'll make a start on that tomorrow.
4
Omega General Help / Re: Temperature Gauge not working
« on: 17 April 2010, 18:48:32 »
Re. the above. I need to change the temp sensor (gauge). Haynes book says just remove intake plenum (upper manifold), TIS says roughly the same but might need to remove drip shield / wiper motor. Has anyone who's done this got any advice before I start?
Pages: [1]