11
« on: 17 July 2015, 15:37:02 »
Hi guys and I am hoping someone on here could shed a bit of light on my problem. I own a 2.6 2002 lpg conversion. I started to get the COOLANT LEVEL problem. I removed the expansion tank to get at the sensor, realised i needed a new tank so ordered one from VX. BUT after replacing the tank, she has started to run like a pig. Read the codes and have 3 cylinders misfiring. Not too bad I thought as I must have dislodged or unplugged something. All looks OK EXCEPT I have a small two pin plug (Similar to the sensor plug from the expansion tank) not plugged in and two pipes that run from the vapouriser, one goes off to the rear of the engine and a faily short one, about 5 inch, goes nowhere. I cannot see where this one is meant to go. Any help gratefully excepted. Pics available if required. Cheers all...